Strider 14x Manual

Bike Tune Up & Safety Checklist

Clamps!
Check that the Quick Release Clamp on the saddle (or seat post) is tight.

• A grown-up should close the lever on the Quick Release Clamp using the palm of their hand and press hard enough to see an imprint. Then give it one last tug with an Allen wrench.
  
• Next, ensure the Standard Clamp on the handlebar is tight by using an Allen wrench (Remember righty tighty, lefty loosey!).
  

Wheels!
Check the tires of your rider's Strider 14x.

• Strider 14x tires require air. You can purchase a typical bike pump at your local bike shop or box store.
• Use the bike pump to fill the tire with air to the 36 PSI (We included that number right on the tire, but please triple check to be sure!).
  

Handlebar!
Check that your rider's handlebar is secure.

• The little groove indicating minimum insertion labeled on the handlebar stem must be inserted in the head tube until this label is no longer visible (approximately one inch).
  

Saddle!
Check that your rider's saddle is secure.

• The little groove indicating minimum insertion labeled on the saddle post must be inserted in the seat tube until this label is no longer visible (approximately one inch).
  

Color!
Is your bike the same color as before? Color in this bike to match yours!

Wheels!
Do your wheels spin?
Make sure they don't get stuck so you can ride as fast as possible!

Handlebar!
Does your bike have a handlebar?
Make sure this isn't missing so you can steer your bike!

Saddle!
Does your bike have a saddle? Make sure this isn't missing so you have a place to sit!

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Strider 14x Manual