Strider 14x Quick Start Manual

Bike Tune Up & Safety Checklist
Clamps!
Check that the Quick Release Clamp on the saddle (or seat post) is tight.
• A grown-up should close the lever on the Quick Release
Clamp using the palm of their hand and press hard
enough to see an imprint. Then give it one last tug
with an Allen wrench.
• Next, ensure the Standard Clamp on the handlebar is
tight by using an Allen wrench (Remember righty tighty,
lefty loosey!).
Wheels!
Check the tires of your rider's Strider 14x.
• Strider 14x tires require air. You can purchase a typical bike
pump at your local bike shop or box store.
• Use the bike pump to fill the tire with air to the 36 PSI
(We included that number right on the tire, but please
triple check to be sure!).
Handlebar!
Check that your rider's handlebar is secure.
• The little groove indicating minimum insertion labeled on
the handlebar stem must be inserted
in the head tube until this label is no
longer visible (approximately one inch).
Saddle!
Check that your rider's saddle is secure.
• The little groove indicating minimum
insertion labeled on the saddle post
must be inserted in the seat tube
until this label is no longer visible
(approximately one inch).
© 2025 Strider Sports International, All Rights Reserved. Strider Bike Tune Up & Safety Checklist.
36 PSI
14x