Canton DIGITAL MOVIE DM 70 Manual page 40

Error
Sound is dull (too little treble)
Sound is too tinny
You have too little upper bass
You have too much upper bass
You have too much lower bass
Your bass levels are incorrectly set
You have a delay between the image
signal of your flat screen and the
audio signal
The signal sounds distorted
Possible causes
1. You are playing back a stereo signal in Virtual
Surround mode
2. Your room has very 'dead' acoustics
1. Your room has very 'live' acoustics
1. The levels for the bass are set too low
1. The levels for the room comp. bass are set too high
2. The DM is very close to the wall or in the corner
1. The DM is very close to the wall or in the corner
2. The setting for „bass expand" is set at medium
1. The levels for the DM are not set correctly
1. The signal processing of the flat screen takes longer
than that of the DM system
1. The processer can overload in the case of
multichannel recordings
2. The level of the system is set too high
Solutions
1. Change the playback mode to Stereo
(Pg.30)
2. Increase the treble levels as described in
„Room settings" (Pg.34)
1. Decrease the treble levels as described in
„Room settings" (Pg.34)
1. Increase the crossover frequency setting as
described in „Room settings" (Pg.34)
1. Decrease the crossover frequency setting as
described in „Room settings" (Pg.34)
2. Reposition the DM further away from the
wall
1. Reposition the DM further away from the
wall
2. Set „bass expand" to normal or bypass
1. Correct the levels
1. Set the required time delay using the „lip
sync" function
1. Change from „dynamic" to „compressed"
(Pg.35)
2. Reduce the volume
4 0