Changing A Doorbell's Settings - Westinghouse WHI-3S - One Piece Intercom Unit Installation And Operation Instructions Manual

TO CHANGE A DOORBELL
1
OR ADD A NEW DOORBELL
THE FACTORY SETTING FOR THE FREQUENCY
SWITCH IS "A", SET THE FREQUENCY SWITCH
TO MATCH THE CONSOLE (EITHER "A" OR "B")
A
PLACE THE DOORBELL INTO PROGRAM MODE
2
AND COUNT THE EXISTING HOUSE CODE NUMBER BEEPS
1. BE SURE THE GREEN POWER LIGHT
IS OFF (IF THE LIGHT IS ON, WAIT ABOUT
2 MINUTES)
2. USE AN OBJECT TO PRESS AND HOLD
THE PROGRAM BUTTON UNTIL A BEEP
SOUNDS
3. RELEASE THE PROGRAM BUTTON
(BE READY TO COUNT BEEPS)
4. THE DOORBELL WILL BEEP, COUNTING
THE EXISTING HOUSE CODE NUMBER
3
SET THE DOORBELL'S NEW HOUSE CODE NUMBER
1. PRESS THE TALK BUTTON
1 TO 15 TIMES TO SET THE
NEW HOUSE CODE NUMBER
2. THE DOORBELL WILL BEEP,
COUNTING THE NEW HOUSE
CODE NUMBER
DOORBELL BEEPS THE
NEW HOUSE CODE
NUMBER

CHANGING A DOORBELL'S SETTINGS

NOTE: UNITS ARE PRE-SET AT THE FACTORY
THE FACTORY SETTING FOR THE STATION SWITCH
IS "5", SET THE STATION SWITCH TO EITHER "4" OR "5"
B
WITH THE SAME HOUSE CODE, CHANGING
THE HOUSE CODE IS ONLY NECESSARY
WHEN ADDING ADDITIONAL UNITS OR TO
AVOID OVERLAP WITH OTHER SYSTEMS
DOORBELL BEEPS THE
EXISTING HOUSE CODE
NUMBER
NOTE: ALL UNITS MUST BE SET TO
THE SAME HOUSE CODE NUMBER
3. PRESS THE PROGRAM
CHIME SOUND:
5 = "DING-DONG"
4 = "DONG"
4
5
PROGRAM
BUTTON
INSIDE HOLE
FACTORY SETTING:
HOUSE CODE = 10
BUTTON TO EXIT
PROGRAM MODE
11