Changing A Console's Settings - Westinghouse WHI-3S - One Piece Intercom Unit Installation And Operation Instructions Manual

CHANGING A CONSOLE'S SETTINGS

TO CHANGE A CONSOLE OR
1 ADD A NEW CONSOLE,
PREPARE THE CONSOLE
FOR PROGRAMMING
THE FACTORY SETTING FOR THE FREQUENCY
SWITCH IS "A", SET THE FREQUENCY SWITCHES
TO MATCH ON ALL CONSOLES (ALL EITHER "A" OR "B")
SET THE MUTE SWITCH TO
OFF WHILE PROGRAMMING
2
SET THE CONSOLE'S STATION NUMBER
1. PRESS A NUMBER BUTTON TO SET THE CONSOLE'S
STATION NUMBER (SELECT A DIFFERENT STATION
NUMBER FOR EACH CONSOLE)
2. THE SELECTED STATION NUMBER INDICATOR
WILL FLASH
NOTE: TO EXIT PROGRAMMING WITHOUT
CHANGING THE HOUSE CODE NUMBER,
PRESS THE TALK BUTTON TWICE
3
SET THE CONSOLE'S NEW HOUSE CODE NUMBER
TALK BUTTON MAKES
THE CONSOLE SOUND
THE EXISTING HOUSE
CODE NUMBER
1. PRESS AND RELEASE THE TALK BUTTON
2. THE CONSOLE WILL BEEP, COUNTING THE
EXISTING HOUSE CODE NUMBER
10
NOTE: UNITS ARE PRE-SET AT THE FACTORY
WITH THE SAME HOUSE CODE, CHANGING
WHEN ADDING ADDITIONAL UNITS OR TO
1. START WITH THE POWER OFF (VOLUME KNOB OFF)
2. PRESS & HOLD DOWN "ALL CALL" & "TALK" BUTTONS
3. TURN POWER ON (TURN VOLUME KNOB ON HALFWAY)
4. WHEN ALL STATION LIGHTS FLASH, RELEASE THE BUTTONS
NOTE: ALL UNITS MUST BE SET TO
THE SAME HOUSE CODE NUMBER
ALL CALL BUTTON
ENTERS THE NEW
HOUSE CODE
NUMBER
FACTORY SETTING:
HOUSE CODE = 10
1. PRESS THE ALL CALL BUTTON 1 TO 15 TIMES
TO SET THE NEW HOUSE CODE NUMBER
2. THE CONSOLE WILL BEEP, COUNTING THE NEW
HOUSE CODE NUMBER
3. PRESS THE TALK BUTTON TO EXIT PROGRAM MODE
THE HOUSE CODE IS ONLY NECESSARY
AVOID OVERLAP WITH OTHER SYSTEMS
SETTING THE
CONSOLE'S
STATION
NUMBER