Standard Equipment - DeWalt 621106-00 Instruction Manual

NOTE: Capacity shown on chart assumes no wheel wear and optimum fence position.
Workpiece Shape:
90˚ Cutting Angle
45˚ Cutting Angle A = 3-13/16"

Standard Equipment

1 14" (355mm) Metal Cutting Abrasive Wheel
1 Wheel Wrench
1 Instruction manual
To Carry (Fig. 1)
Fold down unit to position where you can carry the saw. Push in
lock pin (A) to lock arm down.
Unlocking (Fig. 1)
To unlock tool and raise head, depress motor arm slightly and pull
lock pin (A) out. Motor arm will then pivot upward.
MAXIMUM CUTTING CAPACITY
A = 4.5" A = 4-11/16"
(115mm) (119mm) (115mm x 130mm)
(102mm x 194mm)
A = 3-13/16"
(98mm) (98mm)
Material Clamping and Supporting
• Angles are best clamped and cut with both legs resting against
base.
• A spacer block slightly narrower than the workpiece can be
used to increase wheel utilization (Fig. 2).
• Long workpieces must be supported by a block so it will be
level with top of base (Fig. 3). The cut-off end should be free to
fall downward to avoid wheel binding.
Spark Deflector Adjustment (Fig. 1)
To best deflect sparks away from surrounding persons and
materials, loosen the screw (B), adjust the spark deflector (C)
and then retighten screw. Do not allow cordset to come into contact
with deflector or sparks as damage to cordset may occur.
5
A x B
4-1/2" x 5-1/8" A = 5-3/8"
(137mm)
4" x 7-5/8"
3" x 9"
(76mm x 229mm)
4-1/2" x 3-13/16" A = 3-13/16"
(115mm x 98mm) (98mm)