Genelec W371AP Operating Manual
Genelec W371AP Operating Manual

Genelec W371AP Operating Manual

Sam woofer system

Advertisement

W371A
SAM Woofer System
Operating Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W371AP and is the answer not in the manual?

Questions and answers

Summary of Contents for Genelec W371AP

  • Page 1 W371A SAM Woofer System Operating Manual...
  • Page 2: System Characteristics

    1978. There ́ s already over one million Genelec monitors around the world - welcome to our story! Genelec monitors are designed to last. They are hand-built in Iisalmi, Finland, using certified sustainable methods.
  • Page 3: Audio Inputs

    The GLM software gets the most out of the W371A and tailor- environments, supporting balanced line-level analog audio and fits it to your room. Genelec recommends always using the GLM AES/EBU digital audio. The maximum analog input level is +25 software to set up a W371A.
  • Page 4: Power Management

    Acoustic axis 868 mm 34 3/16 in Figure 5. Location and orientation of the acoustic axis Figure 6. Guidelines for placement of the W371A relative to the monitors. Green area is recommended, yellow acceptable The analog input is selected when the AES/EBU signal input is not connected.
  • Page 5 GLM Network GLM Network GLM Network GLM Network TERMINATOR GLM Network Figure 8. Cabling example for GLM management network; GLM network uses the provided 5-meter CAT cables Analog In Analog In Analog In Analog In Analog Thru Analog Thru Figure 9. Cabling for analogue stereo audio Digital In Digital Thru Digital In...
  • Page 6 GLM Adapter device. to manually edit the acoustic settings, you may want to take a • Download the GLM software from the Genelec web site copy of the automatic settings and then edit the copy. In the (www.genelec.com). Install the GLM software and follow...
  • Page 7: Maintenance

    There are no user serviceable parts inside the monitor. This section is only needed when you wish to manually edit Maintenance or repair must only be done by Genelec certified the monitor loudspeaker acoustic calibrations before calibrating service personnel. The monitor enclosure must not be opened.
  • Page 8: Specifications

    to radio or television reception, which can be determined by • Connect the equipment into an outlet on a circuit turning the equipment off and on, the user is encouraged to different from that to which the receiver is connected. try to correct the interference by one or more of the following measures: Consult the dealer or an experienced radio/TV technician for...
  • Page 9 AMPLIFIER SECTION W371A Short-term amplifier output power (Long-term output power is limited by driver unit protection circuitry) 400 + 400 W Amplifier system THD at nominal output <0.01 % Mains voltage 100-240 VAC 50/60 Hz Power consumption Standby, ISS active <2 W Idle 40 W...
  • Page 10 APPARATET MÅ TILKOPLES JORDET STIKKONTAKT. MADE IN APPARATEN SKALL ANSLUTAS TILL JORDAT UTTAG. FINLAND www.genelec.com APPARATETS STIKPROP SKAL TILSLUTTES EN STIKKONTAKT MED JORD SOM GIVER FORBINDELSE TIL STIKPROPPENS JORD. SERIAL NUMBER This device complies with FCC Part 15 and Canadian ICES 003 radio frequency Class B emission requirements.
  • Page 12 Genelec Document D0158R001a Copyright Genelec Oy 8.2022. All data subject to change without prior notice. In China please contact: International enquiries: In the U.S. please contact: In Sweden please contact: Beijing Genelec Audio Co.Ltd Genelec, Inc., 7 Tech Circle...

Table of Contents