Genelec W371A Operating Manual
  1. Manuals
  2. Brands
  3. Genelec Manuals
  4. Subwoofer
  5. W371A
  6. Operating manual

Genelec W371A Operating Manual

Sam woofer system
Hide thumbs Also See for W371A:
Table of Contents

Advertisement

Quick Links

Download this manual
W371A
SAM Woofer System
Operating Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W371A and is the answer not in the manual?

Questions and answers

Related Manuals for Genelec W371A

Summary of Contents for Genelec W371A

  • Page 1 W371A SAM Woofer System Operating Manual...

  • Page 2: System Characteristics

    The user can select and run the setup of W371A in all the reflex ported woofer system. Each unit is driven by its dedicated...

  • Page 3: Audio Inputs

    Software and GLM User Kit The audio inputs on the W371A integrate with all professional The GLM software gets the most out of the W371A and tailor- environments, supporting balanced line-level analog audio and fits it to your room. Genelec recommends always using the GLM AES/EBU digital audio.

  • Page 4: Power Management

    W371A is placed at the same location as the main monitor with cable management clips. Do not run cables over the woofer the main monitor on top of the W371A (see fig. 6). It is possible transducer. to place the W371A behind or to the side of the main monitor.
  • Page 5 GLM Network GLM Network GLM Network GLM Network TERMINATOR GLM Network Figure 8. Cabling example for GLM management network; GLM network uses the provided 5-meter CAT cables Analog In Analog In Analog In Analog In Analog Thru Analog Thru Figure 9. Cabling for analogue stereo audio Digital In Digital Thru Digital In...
  • Page 6 Do not place the W371A very far from the monitor. Place the Colour Indication W371A more than 10 cm (4 in) from the wall behind in order to Normal state, normal operation Solid green enable air flow for the amplifier and reflex port. Aim the acoustic...

  • Page 7: Maintenance

    Red and yellow colours are used to indicate calibration process for W371A. Frequency sweeps are audible special situations. See Table 1. on the W371A, one woofer at a time, followed by the main Maintenance monitor sweep. After this, the calculation process starts. The progress of the calculation is shown on the GLM page.

  • Page 8: Specifications

    FCC rules. Specifications SYSTEM SPECIFICATIONS W371A Lower cut-off frequency -6 dB (anechoic, continued directivity mode) 23 Hz* Upper cut-off frequency -6 dB (anechoic, continued directivity mode) 500 Hz** Accuracy of frequency response (anechoic, continued directivity mode) ±...
  • Page 9 60° 45° Frequency Hz Figure 11. Frequency response of W371A on the acoustical axis and at 15, 30, 45 and 60 degree off-axis angles on the horizontal Figure 13. Horizontal directivity of W371A. Null Steering Mode - plane - Continued Directivity Mode reduction back wall Figure 14.
  • Page 10 SERVICING TO QUALIFIED PERSONNEL. USE EARTHED MAINS CONNECTION ONLY. AVERTISSEMENT RISQUE DE CHOC ÉLECTRIQUE. NE PAS OUVRIR. NE W371A PAS EXPOSER À L'EAU OU L'HUMIDITÉ. AUCUN COMPOSANT À L'INTÉRIEUR REMPLAÇABLE PAR L'UTILISATEUR. ADRESSER TOUTE RÉPARATION À UN PERSONNEL QUALIFIÉ. CET APPAREIL DOIT ÊTRE RACCORDÉ...
  • Page 12 Genelec Document D0158R001 Copyright Genelec Oy 2.2020. All data subject to change without prior notice. In China please contact: International enquiries: In the U.S. please contact: In Sweden please contact: Beijing Genelec Audio Co.Ltd Genelec, Inc., 7 Tech Circle...

Table of Contents