Table of Contents
Advertisement
Headset state
power being turned on
power being turned off
pairing
pairing succeeded
Charging
fully charged in cradle
table 6:
headset visual signals and their meanings
7.6
batteRy indicatoRS and RechaRGe
Battery indicators
the headset indicates the current headset battery level as follows:
- the headset led indicates, among other things, its battery and charging status; see the table above for details.
- While the battery is low, you will hear an audio signal (two quick, low tones) every minute or so in the headset.
Recharging the Headset
to recharge your headset battery, place the headset into its travel Charger and connect the charger to power.
see also Section 4.1: Charging the headset.
7.7
PoweR Save Mode
you can choose to put the headset into power save mode. the means that the headset saves power at the
expense of a slightly reduced range.
you can enable / disable power save mode from the Jabra Control Center (it is disabled by default).
If the sound is distorted with power save mode enabled, disable it, then turn the headset off and then back on again.
power save mode uses the bluetooth® wireless technology enhanced data rate (edr) feature.
LED when battery level is good
Green 100ms
Off 100ms
repeats to a total of 3 times
red 100ms
Off 100ms
repeats to a total of 3 times
Constant blue
blue 200ms
Off 400ms
repeats to a total of 5 times
Constant yellow
Constant green
Jabra GO 6430 User manUal
LED when battery level is low
same as for good battery level
same as for good battery level
Constant red
red 100ms
Off 300ms
repeats to a total of 5 times
Constant red
n/a
29
Advertisement
Table of Contents
