Table of Contents
Advertisement
Function
of
KCA-BT200 (Optional Accessory)
Bluetooth Setup
Registering Bluetooth device
To make your Bluetooth device (cell-phone) usable
with this unit, you need to register it (pairing). You
can register up to five Bluetooth devices to this unit.
When registering from Bluetooth devices
1
Turn on the control unit.
2
Start registering a unit by operating the
Bluetooth device
By operating the Bluetooth device, register the
hands-free unit (pairing). Select "KENWOOD BT200"
from the list of connected units.
3
Enter a PIN code
Input the PIN code registered as mentioned in
<Registering PIN Code> (page 24).
Check that registration is complete on the
Bluetooth device.
4
By operating the Bluetooth device, start hands-
free connection.
When registering from this unit
• This unit allows up to eight digits to be input for a PIN
code. If a PIN code cannot be input from this unit, it can
be input from the Bluetooth device.
• If there are 5 or more Bluetooth devices registered, you
cannot register a new Bluetooth device.
If the error message appears even though the PIN code
is correct, try <Registering Special Bluetooth device>
(page 23).
Registering Special Bluetooth device
Allow registration of a special device that cannot be
registered normally (pairing).
1 Select Special device registration mode
Select "MENU"
>
"SPCL DVC
Select'~
For how to select Function Control item, refer to
<Function Control> (page 6).
2
Enter Special device registration mode
Press the Control knob for at least 1 second.
A list is displayed.
3
Select a device name
Turn the Control knob and push the center
when the desired device name is displayed.
If "Com pleted" is displayed, registration is
completed.
4
Go through the procedure of <Registering
Bluetooth device> (page 23) and complete the
registration (pairing).
Cancelling Special device registration mode
Press the [FNC] button.
§
• If the device name is not in the list, select "Other
Phones'~
Move to the next digit.
Delete the last digit.
Push the Control knob towards left.
5
Transmit the PIN code
Press the Control knob for at least 1 second.
If"Pairing Success" is displayed, registration is
completed.
6
Return to the device list
Press the Control knob.
7
Exit Bluetooth device registration mode
Press the [FNC] button.
English
I
23
Advertisement
Table of Contents
