Table of Contents
Advertisement
Installation
Installation of Controller
1
According to the installation angle of the controller,
install Spacer (Accessory
@)
to Bracket (Accessory
@)
as described below.
When installing on the O-degree surface
Accessory@
Accessory@
When installing on the 4-degree surface
~
.~
@)
@)
Accessory@
------~---=::..AcceSSOry@)
(02 X 5, Black)
I
KOS-A300
Page 36
When installing on the 8-degree surface
~
AccessoryCf)
(02 X 11.5, Blue)
Accessory@
(02 X 9, White)
~
~
• The direct installation of Bracket (Accessory @) without
Spacer (Accessory @) is also possible.
2
From Spacer (Accessory @), remove the chip in the
direction where you want to wire the controller
cable.
Accessory@
~
~""-
Chip
Break off the spacer chip in the direction where you
want to wire the controller cable.
Drill a hole of 10 mm in diameter on the mounting
surface when not using spacer or wiring the cable
behind the mounting surface.
Advertisement
Table of Contents
