Chapter 2: Board Installation - TYAN THUNDER K8WE Manual

Chapter 2: Board Installation

You are now ready to install your motherboard. The mounting hole pattern of
the Thunder K8WE matches the SSI EEB 3.51 specification. Before continuing
with installation, confirm that your chassis supports an SSI EEB v3.51
motherboard.
How to install our products right... the first time
The first thing you should do is read this user' s manual. It contains important
information that will make configuration and setup much easier. Here are some
precautions you should take when installing your motherboard:
(1) Ground yourself properly before removing your motherboard from the
antistatic bag. Unplug the power from your computer power supply and
then touch a safely grounded object to release static charge (i.e. power
supply case). For the safest conditions, TYAN recommends wearing a
static safety wrist strap.
(2) Hold the motherboard by its edges and do not touch the bottom of the
board, or flex the board in any way.
(3) Avoid touching the motherboard components, IC chips, connectors,
memory modules, and leads.
(4) Place the motherboard on a grounded antistatic surface or on the
antistatic bag that the board was shipped in.
(5) Inspect the board for damage.
The following pages include details on how to install your motherboard into your
chassis, as well as installing the processor, memory, disk drives and cables.
DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN
NOTE
DAMAGED
7
http://www.tyan.com