Applying power to the board
1.
Connect the SSI Workstation 6-pin power connector (if needed).
2.
Connect the 8-pin CPU Power connector.
3.
Connect the 24-pin Main Power connector.
4.
Connect power cable to power supply and power outlet
YOU MUST unplug the power supply before plugging the
NOTE
power cables to motherboard connectors.
2.15 – Finishing Up
Congratulations on making it this far! You' re finished setting up the
hardware aspect of your computer. Before closing up your chassis, make
sure that all cables and wires are connected properly, especially IDE cables
and most importantly, jumpers. You may have difficulty powering on your
system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find
help by asking your vendor for assistance. If they are not available for
assistance, please find setup information and documentation online at our
website or by calling your vendor' s support line.
33
http://www.tyan.com