Attaching Drive Cables - TYAN THUNDER K8S Manual

Memory Installation Procedure
When you install the memory modules, make sure the module aligns properly with the
memory slot. The modules are keyed to ensure that it is inserted only one way. The
method of installing memory modules are detailed by the following diagrams.
Once the memory modules are firmly seated in the slot, two latches on either side will
close and secure the module into the slot. Sometimes you may need to close the
latches yourself.
To remove the memory module, simply push the latches outwards until the memory
module pops up. Then remove the module.
YOU MUST ALWAYS unplug the power connector from the
NOTE motherboard before performing system hardware changes.
Otherwise you may damage the board and/or expansion device.
2.35 – Attaching Drive Cables
Attaching the IDE drive cable is simple. These cables are "keyed" to only allow them
to be connected in the correct manner. TYAN motherboards have two on-board IDE
channels, each supporting two drives. The black connector designates the Primary
channel, while the white connector designates the Secondary channel.
Attaching IDE cables to the IDE connectors is illustrated below:
http://www.TYAN.com
30