Table of Contents
Advertisement
Thunder i7525 (S2676)
3.2.1 - Clear CMOS Switch
J108
3.2.2 - Fan Connector
This 3-pin fan connector supports tachometer monitoring.
There are three 3-pin fan connectors on Thunder i7525 (S2676) board. Use these connectors
to connect chassis and processor cooling fans to your motherboard. Cooling fans can keep
the system stable and reliable for its product's life.
You can reset the CMOS settings by Closing
header J108, if you have forgotten your
system/setup password or need to clear
system BIOS settings.
Reconnect power & power on system
Pin1: GND
Pin2: +12V
Pin3: Tachometer
10
http://www.tyan.com
J108
- Power off system and disconnect
both power connectors from the
motherboard.
- Close J108 for sev eral seconds to
Clear CMOS.
- Remove Jumper
Advertisement
Table of Contents
