I7520R S5360-1U Jumper Settings Quick Reference - TYAN THUNDER I7520, D, R, RD Manual

Thunder i7520 / Thunder i7520R
1.11 – i7520R S5360-1U Jumper Settings Quick Reference
Jumper Function
JP1 CMOS Clear
JP2 Onboard VGA
JP5 Watch-Dog Timer
JP7 PCIX1 Channel B (for
PCIX1-S1 and PCIX1-S2
slots)
JP10 Onboard Intel
NIC
SPK Buzzer/External Speaker
CPU FAN1 CPU1 Fan Connector
CPU FAN2 CPU2 Fan Connector
FAN1 4-pin System Fan
Connector
FAN2 ~ 3-pin System Fan
FAN7 Connectors
J9 External LED Input Header
J34 SMDC Connector
J38 LAN1 LED Header
J40 LAN2 LED Header
USB2 USB Header
P-SATA/ SATA Connectors
S-SATA
JFP (Front Panel Connector)
Signal
HD LED +
HD LED -
GND
Reset Button -
+5V
NC
3Vsb
SMB DATA
SMB CLK
Settings
1-2: Clear CMOS
2-3: Normal
(Refer to Section 3.1.2)
Open: Enable ATI VGA
Close: Disable ATI VGA
(Refer to Section 3.1.3)
1-2: WDT resets system
2-3: WDT generates NMI
(Refer to Section 3.1.4)
Open: Enable 133 MHz maximum frequency
Close: Disable 133 MHz and up to 100/66 MHz
Refer to Section 3.1.5
82546GB Open: Enable dual GbE ports
Close: Disable dual GbE ports
Refer to Section 3.1.9
1-4: For external speaker connector
3-4: Enable onboard buzzer
Refer to Section 3.1.10
Refer to Section 3.1.15
Refer to Section 3.1.15
Refer to Section 3.1.15
Refer to Section 3.1.15
Refer to Section 3.1.11
Refer to Section 3.1.12
Refer to Section 3.1.14
Refer to Section 3.1.14
Refer to Section 3.1.13
Refer to Section 3.1.16
Pin Pin Signal
1 2
PWR LED +
3 4
GND
5 6
PWR_ON-
7 8
GND
9 10
Warning LED+
11 12 GND
13 14 KEY
15 16 GND
17 18 Chassis Intrusion-
13
http://www.tyan.com
Chapter 1: Introduction