Testing The Patch Codes - I.R.I.S. IRISPOWERSCAN 9.0 User Manual

Batch separation: to make the software create a new batch when
detecting the selected patch code.
Document separation: to make the software create a new
document when detecting the selected patch code.
Create attachment: to make the software create an attachment
when detecting the selected patch code.
Delete page: to make the software delete the page is the selected
patch code is detected on the page.
Patch based rotation: tick this option to rotate all the pages of the
document in the same manner as the lead page containing the patch
code.
Search also on 180° rotated images: tick this option to prevent
patch code read failure in case a page is scanned upside down. If the
patch code reading fails on a page, the software will thus look for
the zone after rotating the image by 180 degrees. This slows down
patch code reading.
Search also on rear images: tick this option to make the software
also look for the patch code on the rear sides of the images.

Testing the patch codes

The Patch Code Setup window also enables to test your document
patch codes. Simply select an image in the right part of the window
(drop-down list) and IRISPowerscan will test whether the patch
code can be properly detected.
Tip:
To make an image available for project setup, access the application viewer
and select the image to be used:
- Select the required image in the viewer, right-click on it, and select Copy to
Project Setup.
- The image is directly available in the Project Setup window, Image drop-
down list.
Chapter 5 - Project setup
81