Advertisement

Quick Links

Power Max
Model No. 38834—Serial No. 400000000 and Up

Introduction

This machine is intended to be used by residential
homeowners. It is designed primarily for removing
snow from paved surfaces, such as driveways and
sidewalks, and other surfaces for traffic on residential
or commercial properties. It is not designed for
removing materials other than snow.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com
for product safety and operation training materials,
accessory information, help finding a dealer, or to
register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Heavy Duty 1028 OXE Snowthrower
Figure 1
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
serious injury or death if you do not follow the
recommended precautions.
Register at www.Toro.com.
Figure 1
1. Model and serial number location
Model No.
Serial No.
2), which signals a hazard that may cause
Figure 2
1. Safety-alert symbol
Original Instructions (EN)
All Rights Reserved *3415-864* A
Printed in the USA
Form No. 3415-864 Rev A
Operator's Manual
g217465
g000502

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 38834 and is the answer not in the manual?

Questions and answers

Summarization of Contents

Introduction
Model and Serial Number Location
Locating and recording the model and serial numbers for identification and service.
Safety Alert Symbol
Explains the hazard symbol indicating potential serious injury or death.
Safety
General Safety Guidelines
Outlines crucial safety rules for operating the snowthrower to prevent injury.
Safety and Instructional Decals
Describes the importance and location of safety decals on the machine.
Setup
Loose Parts Identification
Lists and describes parts required for initial setup and installation.
Installing the Upper Handle
Guide for attaching the upper handle assembly to the snowthrower.
Installing Wheel-Clutch-Cable Ends
Instructions for connecting the wheel-clutch cable ends to the machine's levers.
Installing the Traction-Control Linkage
Details on connecting the speed control linkage for proper operation.
Installing the Chute-Control Rod
Guide for installing the rod that controls the discharge chute direction.
Connecting the Wire to the Headlight
Procedure for wiring the headlight assembly to the snowthrower.
Pre-Operation Checks
Engine Oil Level Check
Routine check to ensure the engine has adequate oil before operation.
Tire Pressure Check
Instructions for verifying and adjusting tire pressure for optimal performance.
Skids and Scraper Check
Inspection and adjustment of skids and scraper for ground clearance and wear.
Traction Drive Operation Check
Verifying the proper function and adjustment of the machine's traction drive system.
Operation
Before Operation Procedures
Key checks and preparations required before starting the snowthrower.
Before Operation Safety
Essential safety precautions to follow before operating the machine.
Filling the Fuel Tank
Guidance on safely and correctly filling the fuel tank with appropriate gasoline.
During Operation
During Operation Safety
Critical safety measures to observe while the snowthrower is in use.
Operating Tips
After Operation Safety
Safety guidelines for post-operation handling and storage of the machine.
Preventing Freeze-up after Use
Steps to prevent controls and moving parts from freezing in cold conditions.
Maintenance
Recommended Maintenance Schedule
A table outlining regular maintenance tasks and their recommended intervals.
Maintenance Safety Precautions
Crucial safety rules to follow before performing any maintenance or servicing.
Preparing for Maintenance
Steps to take to ensure the machine is safe to work on before maintenance begins.
Checking Engine-Oil Level
Detailed instructions on how to check and top up the engine oil level.
Storage Procedures
Preparing for Storage
Procedures to follow to safely prepare the snowthrower for long-term storage.
Removing from Storage
Steps to take to get the snowthrower ready for use after storage.
Troubleshooting
Electric Starter Problems
Solutions for problems where the electric starter does not engage or turn.
Engine Starting Issues
Common causes and fixes for the engine failing to start or starting with difficulty.
Engine Running Problems
Troubleshooting steps for an engine that operates unevenly or with poor performance.

Table of Contents