Table of Contents
Advertisement
INSTALLING
Continued
102318
Minimum Non Combustible Material Clearances
If Using Mantel
You must have non combustible material(s) above the fireplace opening. Non
combustible materials (such as slate, marble, tile, etc.) must be at least 1/2 inch
thick. With sheet metal, you must have non combustible material behind it. Non
combustible material must extend at least 8 inches up. If combustible material is
less than 12", you must install the fireplace hood accessory. Even if non combus-
tible material is more than 12", you may need the hood accessory to deflect heat
away from your mantel shelf. See chart below and Figures 6 and 7 for minimum
clearances.
IMPORTANT:
If you cannot meet these minimum clearances, you must operate
heater with chimney flue damper open. Go to Installing Damper Clamp Accessory
for Vented Operation, page 13.
Non Combustible
Material Distance (A)
12" or more
Between 8" and 12"
Less than 8"
Mantel Clearances
If you meet minimum clearance between mantel shelf and top of fireplace opening,
a hood is not required (see Figure 6).
Minimum Non-
Combustible
Material
Figure 6 - Minimum Mantel Clearances Without Using Hood
If above minimum clearances are not met, you must have a hood. Follow
minimum clearances shown in Figure 7 when using hood.
Requirements for
Safe Installation
Non combustible material OK.
Install fireplace hood acessory (GA6050
or GA6052, see Accessories, page 31).
Non combustible material must be
extended to at least 8". See Between 8"
and 12", above. If you cannot extend
material, you must operate heater with
flue damper open.
Mantel Shelf
10"
8"
6"
1 /2
2
"
(A)
1 /2
12"
20"
24
"
3 /4
8"
14"
16
"
Minimum Non-
Distances to
Combustible
Underside of
Material Height
Mantel
Underside of
Mantel Shelf
All minimum
distances are
in inches
Log Set
1 /2
27
"
30"
24"/30" Models
1 /2
18
"
20"
18" Model
Top of Fireplace
Opening
Continued
11
Advertisement
Table of Contents
