Installing Glass Panel - Desa Vanguard GVR35PA Owner's Operation And Installation Manual

INSTALLING
HEATER
Continued
100791

INSTALLING GLASS PANEL

For Radiant Models Only
1. Locate the glass panel package inside the back of the heater.
Before installing glass panels, inspect the edges. If you
notice any chips or cracks, do not install. If the surface
on either side is deeply scratched, do not install. If
these conditions exist, contact your Vanguard Dealer
for replacement glass panels.
Do not operate heater without glass panels installed.
Operating heater without glass panels will damage front
of heater due to excess temperatures.
Glass panels may have sharp edges. Handle with care.
2. Remove lower front access panel of heater by removing two screws at upper
corners of panel. The lower front access panel covers the lower front access
area (see Figure 9, page 14).
3. Remove two screws on glass guard. Remove glass guard (see Figure 11).
4. Carefully insert one glass panel up through lower front access area (see Figure 11).
5. Carefully slip glass panel behind hearth assembly (see Figure 11).
Screw
Glass
Panel
Lower Front
Access Area
Figure 11 - Inserting Glass Panels
CAUTION
WARNING ICON G 001
CAUTION
WARNING ICON G 001
CAUTION
WARNING ICON G 001
Glass
Guard
Hearth
Assembly
Continued
15