Vanguard VI33NR VI33PR Owner's Operation And Installation Manual page 15

Unvented (vent-free) gas fireplace insert
Hide thumbs Also See for VI33NR VI33PR:
Table of Contents

Advertisement

INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL ACCESSORIES
Installing Remote Receiver Unit
1. Disconnect switch wires from the control valve.
2. Remove screws attaching switch plate.
3. Remove switch plate (see Figure 26). Discard after removing.
4. Install remote receiver unit onto gas log heater base using
mounting clips.
5. Push clips firmly into place (see Figure 27).
6. Connect wires as shown in Figure 28.
Remote Switch
Bracket
Screw
Switch
Plate
Figure 26 - Switch Plate and Wiring Harness
Mounting
Clips
Remote Receiver
Figure 27 - Installing Remote Receiver
White Wire
From
Receiver
Red Wire
From
Receiver
Figure 28 - Connecting Wires
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are required to operate this
heater with the wireless hand-held remote control set. Install one
battery in the receiver and one in the hand-held remote control unit.
Note: Only use alkaline batteries.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111285-01B
Optional Wireless Hand-Held Remote Control Accessories
(GHRCB and GHRCTB)
Ignitor
Wires
Valve
Installing 9-Volt Batteries
Installing 9-Volt Battery (Not Included) in Receiver
1. Locate back of receiver under front burner of heater.
2. Locate the battery clip mounted on the back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Remote
Receiver
9-Volt
Battery
Battery Clip
Figure 29 - Installing Battery in Remote Receiver
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery. Place battery into the bat-
tery housing.
3. Replace battery cover onto remote control unit.
Battery
Cover
Terminal Wires
9-Volt
Battery
Figure 30 - Installing Battery in Hand-Held Remote Control Unit
(GHRCB Series)
9-Volt
Battery
Battery
Cover
Figure 31 - Installing Battery in Hand-Held Remote Control Unit
(GHRCTB Series)
INSTALLATION
Terminal
Wires
Remote
Control Unit
Battery
Housing
Terminal
Wires
Remote
Control
Unit
15
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vi33nrVi33pr

Table of Contents

Save Article as PDF