Page 30
ENGLISH Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. General description (Fig. 1) Click-on trimmer attachment Click-on shaving unit Handle Socket for small plug Battery charge indicator ’Unplug for use’...
Page 31
ENGLISH future reference. The accessories supplied may vary for different products. Danger - Keep the adapter dry. Warning - The adapter contains a transformer. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience...
Page 32
This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. Electromagnetic fields (EMF) - This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields. General - This shaver is waterproof.
Page 33
ENGLISH The display Charging Battery charge indicator - Charging takes approx. 1 hour. - Quick charge: When the appliance does not contain enough energy for one shave, the battery charge indicator flashes fast. When the battery charge indicator starts to flash slowly, the appliance contains enough energy for one shave.
Page 34
ENGLISH ’Unplug for use’ reminder - The appliance is equipped with an ‘unplug for use’ reminder. The ‘unplug for use’ starts to flash to remind you that you have to disconnect the appliance from the adapter before you can switch it on.
Page 35
ENGLISH - The travel lock symbol flashes and then lights up continuously. The shaver is now ready for use again. Replacing shaving heads For maximum shaving performance, we advise you to replace the shaving heads every two years. - The appliance is equipped with a replacement reminder which reminds you to replace the shaving heads.
Page 36
ENGLISH Charging in the SmartClean system (S7311/26, S7310/26 only) Put the small plug in the SmartClean system. Put the adapter in the wall socket. Press down the top cap to be able to place the shaver in the holder (‘click’).
Page 37
ENGLISH Shaving Skin adaptation period Your first shaves may not bring you the result you expect and your skin may even become slightly irritated. This is normal. Your skin and beard need time to adapt to any new shaving system. We advise you to shave regularly (at least 3 times a week) with this shaver for a period of 3 weeks to allow your skin to adapt to the new shaver.
Page 38
ENGLISH Move the shaving heads over your skin in circular movements. Note: Rinse the shaver under the tap regularly to ensure that it continues to glide smoothly over your skin. Dry your face and thoroughly clean the shaver after use (see chapter ‘Cleaning and maintenance’).
Page 39
Note: The accessories supplied may vary for different products. The box shows the accessories that have been supplied with your appliance. Cleaning the shaver in the SmartClean system (S7311/26, S7310/26) Do not tilt the SmartClean system to prevent leakage. Note: Hold the SmartClean system while you prepare it for use.
Page 40
ENGLISH Press the button on the side of the SmartClean system and lift the top part of the SmartClean system. Pull the seal off the cleaning cartridge. Place the cleaning cartridge in the SmartClean system. Push the top part of the SmartClean system back down (‘click’).
Page 41
ENGLISH Press down the top cap to be able to place the shaver in the holder (‘click’). Hold the shaver upside down above the holder. Make sure the front of the shaver points towards the SmartClean system. Place the shaver in the holder, tilt the shaver backwards and press down the top cap to connect the shaver (‘click’).
Page 42
ENGLISH Note: If you remove the adapter from the wall socket during the cleaning program, the program aborts. Note: 30 minutes after the cleaning program and charging have been completed, the SmartClean switches off automatically. Replacing the cartridge of the SmartClean System Replace the cleaning cartridge when the replacement symbol flashes orange or when you are...
Page 43
ENGLISH Cleaning the shaver under the tap Clean the shaver after every shave for optimal shaving performance. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads.
Page 44
ENGLISH Pull the shaving head holder off the bottom part of the shaving unit. Turn the retaining rings anticlockwise and remove them. Remove the shaving heads from the shaving head holder. Each shaving head consists of a cutter and guard. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets.
Page 45
ENGLISH Put the shaving heads back into the shaving head holder. Note: Make sure the notches on both sides of the shaving heads fit exactly onto the projections in the shaving-head holder. Place the retaining rings back onto the shaving head holder and turn them clockwise.
Page 46
ENGLISH Cleaning the click-on attachment Never dry the trimmer attachment with a towel or tissue, as this may damage the trimming teeth. Cleaning the trimmer attachment Clean the trimmer attachment every time you have used it. Switch on the appliance with the trimmer attachment attached.
Page 47
The shaving unit symbol will light up to indicate that the shaving heads need to be replaced. Replace damaged shaving heads immediately. Only replace the shaving heads with original Philips shaving heads as specified in chapter ‘Ordering accessories’. The shaving unit symbol lights up continuously when you switch off the shaver to indicate that the shaving heads need to be replaced.
Page 48
ENGLISH Note: Make sure the notches on both sides of the shaving heads fit exactly onto the projections in the shaving-head holder. Place the retaining rings back onto the shaving heads and turn them clockwise. - The retaining ring has two recesses that fit exactly in the projections of the shaving head holder.
Page 49
7 sec. Ordering accessories To buy accessories or spare parts, visit www. shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). Shaving heads - We advise you to replace your shaving heads every two year.
Page 50
Take out the battery holder and cut the battery tags with a pair of cutting pliers. Guarantee and support If you need information or support, please visit www.philips.com/support or read the separate worldwide guarantee leaflet. 7000Series_EN_A6_CS6new.indd 49 15/05/19 13:3...
Page 51
This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, visit www.philips.com/ support for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Page 52
(see chapter symbol flashes to ‘Cleaning and maintenance’). indicate you have to replace the cleaning cartridge. You have used Only use the original another cleaning Philips cleaning cartridges. fluid than the original Philips cleaning cartridge. 7000Series_EN_A6_CS6new.indd 51 15/05/19 13:3...
ENGLISH Problem Possible cause Solution Water is leaking During cleaning, This is normal and not from the bottom water may collect dangerous because all of the shaver. between the inner electronics are enclosed in body and the outer a sealed power unit inside shell of the shaver.
Need help?
Do you have a question about the S7310/12 and is the answer not in the manual?
Questions and answers