Replacing The Hard Disk Drive - IBM THINKPAD G40 Series Service And Troubleshooting Manual

Replacing the hard disk drive

You can replace a damaged hard disk drive yourself.
Note: Replace the hard disk drive only if you have it repaired. The connectors
Attention
Handling a hard disk drive
v Do not drop the drive or subject it to physical shocks. Put the drive on
v Do not apply pressure to the cover of the drive.
v Do not touch the connector.
The drive is very sensitive. Incorrect handling can cause damage and
permanent loss of data on the hard disk. Before removing the hard disk
drive, make a backup copy of all the information on the hard disk, and
then turn the computer off. Never remove the drive while the system is
operating, in standby mode, or in hibernation mode.
To replace the hard disk drive, do the following:
1. Turn off the computer; then disconnect the ac adapter and all cables
2. Close the computer display, and turn the computer over.
3. Remove the battery.
4. Remove the screw that secures the hard disk drive.
and bay of the hard disk drive were not designed for frequent changes,
or drive swapping. The IBM Rescue and Recovery workspace and the
Product Recovery program are not included in the replacement hard
disk drive.
a material, such as soft cloth, that absorbs the physical shock.
from the computer.

Replacing the hard disk drive

Chapter 2. Solving computer problems
33