Commercial undercounter air cooled ice maker (14 pages)
Summary of Contents for coldline ICE180
Page 1
USER MANUAL COMMERCIAL UNDERCOUNTER AIR COOLED ICE MAKER MODEL: ICE80, ICE120, ICE180, ICE280 USR Brands, Inc. Phone: 800-764-1172 | www.usrestaurant.com | sales@usrestaurant.com USRESTAURANT® RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE...
Table of Contents Important Information............................1 Warning and safety instruction........................2 General................................3 Installation................................ 3 Location for Installation..........................3 Schematic Diagram of Installation......................4 Installation Steps............................5 Startup and Operation..........................5 Operation Instruction............................6 Instruction of Control Panel........................... 7 Maintenance..............................9 Service Call..............................11 Common Faults and Troubleshooting....................... 11 Warranty.................................
Important Information Please pay attention to the following warning labels on the ice maker The label indicates a flammable foaming agent “Cyclopentane” used. There is a risk of fire. The label indicates a hazardous voltage. There is a risk of electric shock. The label indicates a flammable refrigerant “R290”...
Warning and safety instruction store volatile flammable This product cannot be used in outdoor substances in this ice machine, or it may environment. result in explosion or fire. This ice machine is not intended for Do not store any sundries, or freeze any ...
DANGER – RISK FIRE EXPLOSION. FLAMMABLE REFRIGERANT USED.DO NOT USE ANY ELECTRICAL APPLIANCES IN THE ICE STORAGE BIN OF THE ICE MAKER. maker with CAUTION – RISK FIRE flammable refrigerant R290: EXPLOSION. FLAMMABLE DANGER – RISK FIRE REFRIGERANT USED.
3. Installation Steps 1. Check if the ice machine is in good marker on the filter head cover or the filter condition and the accessories are complete; body. check the machine model and the machine Note: This machine is equipped with nameplate.
Operation Instruction the water pump is turned off, the Startup: after proper installation, connect defrosting valve is turned on, and after the water source and turn on the power the hot gas enters into the evaporator for supply, the machine will start working. about 1-2 minutes, the ice cubes slides Please confirm that the machine is from the evaporator into the storage bin.
Instruction of Control Panel announcement prompts will provide voice 1. LED Display: prompts for related operations. Self-check: Display “ini” code. 7. Please open and close the storage bin door Preparing: Counting secondspositively. gently. Do not slam the door. After taken the Ice making: Counting seconds positively ...
Page 10
Water shortage Protective shutdown The fault code and its comments are High pressure Protective shutdown displayed as follows: Condensation Not stop Code Comments Machine action sensor open Error LED light on Sliding board fails Protective shutdown every 5s circuit Overtime of ice Protective shutdown Condensation...
Maintenance further affecting the cooling effect. Note: Maintenance must be done by a The condenser filter should be cleaned qualified professional personal. every 2 weeks. Warning: Before maintenance or manual clean, be sure to cut off the water source and power supply. Exterior cleaning ...
Page 12
ice maker will get into rinsing process; the process will take about 25 minutes. The ice maker will get back to do ice making as soonas the clean process end. Please throw away the next 5 batches ice in case of cleaner remained.
Service Call If the ice machine works abnormally, please whether the panel display does not display confirm below before making a service call: the OFF standby state; 1. Check the water supply If the LED on the display panel is not ON, ...
Warranty The following circumstances are not covered by the warranty: Normal cleaning or maintenance; Unauthorized modification of the ice machine or use of non-native parts; Damage caused by improper power supply, water supply and drainage; Damage caused by installing, cleaning or maintaining of the ice machine not in accordance with ...
Need help?
Do you have a question about the ICE180 and is the answer not in the manual?
Questions and answers