Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Glenair 601-106
Summarization of Contents
Safety and Initial Set-up
General Safety Precautions
Important safety rules for operating the pneumatic banding tool.
Air Supply and Pressure Requirements
Connect air supply, set pressure, and notes on air dryers and lubricators.
Tool Setup and Mounting
Factory settings, caution on tensioning, and regulator mounting.
Regulator Assembly and Setup
Tool and Regulator Assembly
Assemble tool and regulator using coil hose.
Pressure Setting and Adjustment
Adjust regulator to achieve correct psi for band type.
Operating the Band-Master® ATS Tool
Band Insertion and Tensioning
Insert band tail and hold actuator to tension.
Automatic Cut-Off and Post-Cutoff
Tool cuts band, checks switch if needed, release actuator, remove band.
Counter Features and Operation Notes
Counter Display and Power
Explains resettable count, permanent count, battery life, power switch.
Critical Operating Precautions
Notes on air pressure, regulator adjustment, clamping, etc.
Maintenance Procedures
Draining Water from Filter Assembly
Steps to drain accumulated water from the filter assembly.
Cleaning or Replacing Filter Element
Instructions for cleaning or replacing the filter element.
Cut-Off Timer Adjustment
Adjusting Cut-Off Delay
Adjust the cut-off timer screw for desired delay.
Cutter Knife/Blade Replacement
Procedure for Replacing Cutter
Steps to remove, replace, and install the cutter knife or blade.
Counter Battery Replacement
Replacing the Counter Battery
Steps to remove old battery and install a new one.
Banding Inspection and Tensioning
Initial Setup and 601-106 Tensioning
Read instructions, then adjust regulator for 44 psi for 150 lb pull.
601-107 Tensioning and Band Compatibility
Adjust regulator for 23 psi; check band width compatibility.
Clamp Inspection and Troubleshooting
Inspect clamps, check tension/blade, re-calibrate if needed.
Replacement Parts
601-106 Standard Tool Parts
Lists user-replaceable parts, specifically the knife/blade kit.
601-107 Micro Tool Parts
Lists user-replaceable parts, specifically the knife part.
Band Selection Guide
ATS Band Part Numbers and Specs
Table detailing part numbers, diameters, and lengths for various bands.
Accessories and Controls
Tool Balancer Installation
How to install and use the tool balancer with the tool.
Foot Pedal Control Overview
Introduction to the foot pedal control and reference to installation.
Bench Mounting Configurations
Top of Bench Set-up
Diagrams showing how to set up the tool on top of a bench.
Under Bench Set-up
Diagrams showing how to set up the tool under a bench.
Foot Control and Bench Mount Kit Installation
Mounting Bracket and Foot Control
Steps for installing the foot control and bench mount bracket.
Need help?
Do you have a question about the 601-106 and is the answer not in the manual?
Questions and answers