American DJ Audio XDM-221 User Instructions

Advertisement

User Instructions
X D M - 2 2 1
PREAMP MIXER
Thank you for purchasing this American DJ® product. The XDM-221 is ready to be used,
there is no assembly required. Please read the following instructions before installing
or using your new unit. The XDM-221 has a 2 year limited warranty!
C A U T I O N ! -
Keep this device away from rain and moisture!

Safety Instructions

Always plug in the power last. Make sure that the Power switch is set to the OFF position before connecting other devices
to the mixer.
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch on the mixer
immediately. The arising condensation of water might damage your device. Leave the device switched off until it has
reached room temperature.
Never put any liquids on the mixer or close to it. Should any liquid enter the device, disconnect from main power
immediately. Have the device be checked by a qualified service technician before operating again. Any damage caused by
liquid entering the device is not subject to warranty!
Never let the AC cord come in contact with other cables! Handle the AC cord and all AC connections with particular care.
Make sure that the available voltage is not higher than stated on the AC voltage selector (22).
Before the device is switched on, all fader and volume controls should be set to 0 or minimum position.
Damages caused by manual modifications to the device or unauthorized operation by unqualified persons are not
subject to warranty.
There are no user serviceable parts inside the mixer. For maintenance and/or service, contact an authorized
American DJ® dealer.
© American DJ® AUDIO Los Angeles, CA 90058 USA
Specifications subject to change without notice. XDM-221 User Instructions page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XDM-221 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for American DJ Audio XDM-221

  • Page 1 X D M - 2 2 1 PREAMP MIXER Thank you for purchasing this American DJ® product. The XDM-221 is ready to be used, there is no assembly required. Please read the following instructions before installing or using your new unit. The XDM-221 has a 2 year limited warranty!
  • Page 2 (16 & 17) on the rear panel. You can only control the line signals after switching the PHONO/LINE switches (2) to LINE. The signal is then controlled via the CH-1 and CH-2 faders (4). © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-221 User Instructions page 2...
  • Page 3 (9) CUE SWITCH CHANNEL 1 / CHANNEL 2 - Use the cue switch in order to select the channel to be monitored. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-221 User Instructions page 3...
  • Page 4 (22) AC VOLTAGE SELECTOR - Make sure that the selector is properly set desired voltage (115V or 230V). (23) MIC INPUT - 1/4 inch (6.3 mm) jack plug for microphone input to mixer. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-221 User Instructions page 4...
  • Page 5 10” W x 7.5” D x 3.75” H 256 x 192 x 100 mm Weight 5 lbs. / 2.3 kg © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-221 User Instructions page 5...

Table of Contents