Nelson N800i Operating Manual

Operating the N1500i FACS Stud
Welding System
Operations Manual
(729-110-053)
For Dot Matrix Units Software Version 1.00 and later
These instructions are for experienced operators. If you are not fully familiar with
the principles of operation and safe practices for arc welding equipment, we urge you
to read AWS SP -"Safe Practices" available from the American Welding Society. Do not
permit untrained persons to install, operate or maintain this equipment. Do not
attempt to install or operate this equipment until you have read and fully
understand these instructions. If you do not fully understand these instructions,
contact your supplier for further information. Be sure to read the Safety section before
utilizing this equipment. .
Part No. 729-110-053 V.1.03 © 2018 Nelson Stud Welding, Inc. All rights reserved.