Table of Contents
Advertisement
Q-D6™
Top Panel
15
14
13
12
11
10
1. SOURCE SELECTOR SWITCH - These switches are used to select the input source assigned to
each channel. Each channel may only be assigned one input source at a time. This switch must be in
the "phono" position for turntable operation.
2. POWER L.E.D. - This L.E.D. will glow when the power is switched on.
3. CHANNEL GAIN CONTROL - This adjustment is used to adjust an audio source signal input gain
for a channel. Never use the gain control to adjust output volume. Setting the gain level properly will
ensure a clean output signal. To properly set the gain level controls:
1. Be sure the MASTER VOLUME CONTROL (4) is set to level 4.
2. Set the CHANNEL FADER (9) to level 8.
3. Begin playback on an audio source connected to the channel you are adjusting.
4. Use the Gain Control (3) to adjust an average output volume of +4 dB.
5. Repeat this step for all channels
4. MASTER VOLUME CONTROL - This rotary knob is used to control the master output level (volume).
To avoid distorted output try to maintain an average output signal level +4 dB. Be sure this volume
American Audio
- www.americanaudio.us - Q-D6™ Instruction Manual Page 7
©
®
Controls and Features
1
2
3
4
5
6
7
8
9
Advertisement
Table of Contents
