Q-2422/SX Featuring Fader “Q” Start Main Features • 2 phono, 4 line, 2 auxiliaries & 2 mic inputs • Fader "Q" On/Off switch • RCA and Balanced XLR Outputs • High quality Alps Feather Fader™ for smooth, clean cross fading •...
Page 3
Quick Start Instructions: American DJ would like to thank for your purchase of this great product. For those of you that are to impatiant to read the entire user manual we have compiled these quick start instructions. We hope that you will at least read through these instructions to familirize yourself with the basic understanding of the unit.
Contents • Safety Instructions....................p.4 • Operating Determinations...................p.5 • Connections.......................p.5 • Functions (Front Panel)..................p.6-7 • Inputs & Outputs (Rear Panel)................p.7-8 • Replacing the Crossfader..................p.9 • Technical Specifications..................p.10 • Warranty & Service....................p.10 Thank you for purchasing the Q-2422/SX™ by American DJ . This unit is ready to be used, there Is no assembly required. ®...
Operating Determinations When installing this mixer, please make sure that the device is not exposed to extreme heat, moisture or dust! There should not be any cables lying around. Doing so endangers you as well as others. Do not operate the mixer in extremely hot (more than 30°...
Front Panel (1) POWER SWITCH - Red LED will light when power is ON. (2) MASTER LEVEL - Dual LED's show the level of the left and right master output. (3) CHANNEL GAIN CONTROL - Used to set the level of the output signal for its designated channel. (4) CHANNEL BASS/MID/TREBLE CONTROL - Used to increase or decrease the LOW's, MID’s, and HI’s of the output signal.
Page 7
Front Panel Cont. hot, meaning that when the microphone is in use all channels attenuate -15dB except the MIC. When the microphone is not being spoken into all channels return to normal. In the OFF position, all signals return to their original level and the microphone is off.
Rear Panel 37 36 (25) GND (GROUND TERMINALS) - Connect the ground lead of the turntables with these terminals. This will reduce humming and popping noises. There are two convenient ground terminals located on the rear of the mixer. (26) AC VOLTAGE SELECTOR - Select between 115V/50Hz or 230V/60Hz. Make sure that the selector is set to the proper voltage you are using.
Rear Panel Cont. (36) PHONO / AUX SELECTOR SWITCH - Changes phono to an extra line; allows the DJ to use a CD player or other input device in the same line as the phono line. When using a turntable select PHONO, and when using other input devices select AUX.