Trim Indicator; Engine Fault Alarms - NorthStar SMARTCRAFT GATEWAY Manual

3-4 Trim indicator

When the engine trim is adjusted, a trim popup
window can show the new trim angle. To see this
window or not, set Trim popup to On or Off (see
section 3-7). The window will automatically disap-
pear after two seconds, or else press
make the window disappear.
Before use, calibrate trim (see section 3-8-2).

3-5 Engine fault alarms

There are many SmartCraft engine fault alarms.
These alarms operate just like the other alarms in
the Navman instrument; when the alarm sounds,
press to mute the alarm:
Low reserve oil.
Low remote oil.
RPM over speed.
Low oil pressure.
High engine voltage.
Low engine voltage.
A Navman instrument's low battery alarm
measures the voltage the instrument; the
above two alarms measure the voltage at the
engine.
Low block (water) pressure.
Engine overheat.
Low drive lube.
(MerCrusier stern drive only).
Water in fuel.
Engine Guardian
Guardian has detected a fault. The fault is
displayed with the alarm.
12
or
active: The Engine
TM
to
Engine communication lost: The
man instrument can not receive
data from the SmartCraft gateway.
Check engine: There are many other engine
fault alarms. When one of these alarms
sounds, the alarm Check engine is displayed.
For more information about the alarm,
display the list of active alarms or the alarm
history (see section 3-6).
Notes:
1 For help when an SmartCraft alarm occurs,
contact your Mercury dealer.
2 These SmartCraft alarms are always on. The
alarm values are determined by the engine
type.
3 A list of active faults and a fault history can be
displayed (see section 3-6).
NAVMAN
SmartCraft gateways Installation and Operation Manual
Nav-
engine