NorthStar 6 KW RADAR Installation Manual page 7

Preface
This manual explains how to install the scanner and the radar processor. It also explains how to set
up the radar system after installation and gives information on troubleshooting.
This manual is supplementary to the Northstar 6000i/6100i Installation and Operation Manual and the
Northstar 8000i System Installation Manual.
This manual is written for professional marine technicians, installation technicians, and service
technicians, and can be used for information by dealers.
PLEASE READ CAREFULLY BEFORE USE
Ensure that mains power is OFF before starting installation or servicing work. Electrical shock, fire or injury can
result if electrical power remains ON, or is switched ON, during installation or servicing work.
A potentially lethal high voltage is present and can remain for a period of time after the equipment is turned OFF.
Ensure that capacitors are discharged with an Earthed wire before starting servicing work.
To minimize accidents, wear dry cotton gloves and avoid touching equipment with both hands unless absolutely
necessary. Always work from a stable position to avoid slipping or falling onto the equipment.
The skipper must make final decisions based on all of the information sources to hand
Install the scanner in an elevated position to minimize the radiation hazard to personnel.
Northstar 6 kW Radar Installation Manual
WARNING indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a potentially hazardous situation which, if not avoided, may result
in minor or moderate injury.
CAUTION used without the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
Ensure that internal surfaces are no longer charged before you touch them.
The radar is intended ONLY as an aid to navigation.
and must not rely solely on the radar.
1