Post Installation Tasks - Dell PowerVault MD3200 Deployment Manual

Post Installation Tasks

Before using the PowerVault™ MD3200 Series storage array for the first time,
complete a number of initial configuration tasks in the order shown. These
tasks are performed using the MD Storage Manager (MDSM) software.
1 For out-of-band management, you must set the network configuration for
each RAID controller module, including its Internet Protocol (IP) address,
subnetwork mask (subnet mask), and gateway.
NOTE:
You can set the network configuration using a DHCP server.
2 Start MDSM.
• On Microsoft
ProgramsDellMD Storage ManagerModular Disk Storage
Manager Client.
• On Linux operating systems, click the MD Storage Manager desktop
icon. You can also launch MD Storage Manager in Linux by running
the following commands at the command prompt:
cd
/opt/dell/mdstoragesoftware/mdstoragemanager/c
lient
./SMclient
3 In the Enterprise Management Window (EMW), go to Setup Add
Storage Array and start the automatic discovery of systems.
NOTE:
Only storage arrays configured with IP address on the same subnet as
the management stations will be detected.
NOTE:
It may take several minutes for the discovery process to complete.
Closing the Automatic Discovery Status window before this stops the
discovery process.
After discovery is complete, a confirmation screen appears. Click Close to
close the screen.
® ®
Windows operating systems, click Start
Post Installation Tasks
4
29