Dell PowerVault MD3060e Installation Manual page 8

Function Command
To enable or disable # cimconfig -s slp={true | false} -p
service location
If SLP is enabled, see the table below for additional settings information.
protocol (SLP)
Commands are of the following format: cimconfig -s <propertyName>={true|
false} -p where
Table 1. Additional Setting Information if SLP is Enabled
runinternal runinternal
PegasusSLP PegasusSLP
true false
false true
false false
false false
false true
NOTE: All other combinations of the SLP property values have undefined behavior.
For more information, see the documentation available in the source release archive at openpegasus.org.
8
<propertyName> is a column heading in the following table.
propertyName
registerExter
nal
PegasusSLP
false
false
true
true
false
register Behavior
Multiple SLP
false Internal Pegasus SLP is
started when cimserver
starts.
false External Pegasus SLP
registration runs in
cimserver with a
default registration
timeout set to 3 hours
(same as the SLP
default timeout).
false External OpenSLP
registration is run in
CIM server.
true External OpenSLP
registration is
attempted and falls
back to external
Pegasus SLP
registration if it fails
(default setting).
true External Pegasus SLP
registration is
attempted and falls
back to external
OpenSLP registration if
it fails.