Related Manuals for EURA ELH-72B9 SILVER
Summary of Contents for EURA ELH-72B9 SILVER
- Page 1 Door hanDle SeT WITh aCCeSS ConTrol elh-72B9 elh-62B9 BraSS BraSS elh-62B9 elh-72B9 SIlVer SIlVer elh-82B9 BraSS elh-82B9 SIlVer Instruction manual...
-
Page 2: Table Of Contents
INDEX 1. GENERAL CHARACTERISTICS AND INTENDED USE ................ 4 2. AVAILABLE DooR HANDLE SET VERSIoNS ..................4 3. SET CoNTENTS: ........................... 4 4. PRINCIPLE oF oPERATIoN .........................5 5. INSTALLATIoN oF LoCK IN DooR ......................5 5.2. INSTALLATIoN IN DooR WITHoUT oPENINGS ............... 6 5.3. - Page 3 PRELIMINARY COMMENTS Please read this instruction manual carefully prior to installation, connection and use of the device. In case of any issues with understanding of its contents please contact the device vendor. Self-installation and start up of the device is possible under the condition of using appro- priate tools.
-
Page 4: General Characteristics And Intended Use
1. GENERAL CHARACTERISTICS AND INTENDED USE Access control door handle sets enable simple restriction of access to unauthorized persons to protected areas. They are intended for both left- and right-hand door wings, and the versatile spacing of fixing screws of 38~40.5 mm in the majority of cases enables use of a lock that has already been installed in the door. -
Page 5: Principle Of Operation
4. PRINCIPLE OF OPERATION Following an impulse from the electronic access control module, the servomotor unlocks mechanical transmission, thus enabling door opening via normal pressing of the door han- dle on the external door handle set. Opening is signalled via sound and LED being switched on. -
Page 6: Installation In Door Without Openings
Fig. 4. 5.1. INSTALLATION IN DOOR WITH OPENINGS In order to install the ELH-62B9/ ELH-72B9 / ELH-82B9 door handle sets, first check wheth- er the door possesses a. suitable lock (Fig. 4 and installation openings for screws/ bushings with 38~41 mm spac- ing (Fig. -
Page 7: Setting Handle Orientation (Left-/Right-Hand Door)
Note 1. Template (to be cut out) with the spacing of installation openings in 1:1 scale is provided on page 13 of this guide. 2. In the case of using ELB-06B9 washers (bezels) performance of the 25 mm opening can be omitted (Fig. -
Page 8: Emergency Entrance
Fig. 6. 5.4. EMERGENCY ENTRANCE Fig. 7. In the case of a necessity to enter the room, the following shall be done using the emer- gency key: - remove the hole plug (Fig. 7, Item 1), - insert the emergency key in the patent lock (Fig. 7, Item 2), - by turning the key 90 degrees to the right unlock the door handle set mechanism, - by pressing down the handle enter the room. -
Page 9: Setting And Installation Of The Arbor In The Door Handle Set
5.5. SETTING AND INSTALLATION OF THE ARBOR IN THE DOOR HANDLE SET The arbor shall be placed in the socket located in the device body marked with triangle (Fig. 9, Item 10), and the install the locking pin located in the accessory set. Warning! By installing the pin in the arbor remember that the element located on the lock body is directed towards the handle (Fig. -
Page 10: Programming And Operating Elh-62B9/Elh-72B9 Door Handle Sets
- place the internal portion of the door handle set and screw the fixing screws into the openings located next to the handle, into the bushings in the external portion, - remove the cover of the battery chamber (Fig. 9, Item 1) using a special key included in the set or other sharp tool - place 4 alkaline 1.5 V batteries type AA into the power supply chamber, - code the lock (see item 7) -
Page 11: Access Code Programming
6.2. ACCESS CODE PROGRAMMING ELH-72B9 door handle set models, apart from the card reader are equipped with numerical keypad, enabling access to the protected zone using a digital code (PIN). After the entire lock is assembled and connected to power supply, the access cards can be programmed to cooperate with the lock (in the manner described in the chapter no. -
Page 12: Programming And Operating Elh-82B9 Door Handle Set
7. PROGRAMMING AND OPERATING ELH-82B9 Door handle SET Prior to the first start up and programming, place 4 working 1.5 V batteries type AA in the battery chamber and connect all plugs in accordance with the chart shown in Fig. 9. Note: For the door handle set to operate properly, it is recommended to use alkaline batter- ies, and not rechargeable batteries. -
Page 13: Operating The Device
7.4. OPERATING THE DEVICE 7.4.1. The lock icon in the upper portion of the app screen enables releasing the lock that remains in the range of the Bluetooth transmitter in the device with the app installed. 7.4.2. „Send eKey” - eKeys are access keys, which can be send to other app users, typically dedicated to the personnel operating the protected room. - Page 14 7.4.3.4. From the list, select the code transmission method: - WeChat - the code will be sent via WeChat app, under the condition the WeChat app is configured; - Text Meg - the code will be sent via a text message- the text message will contain a template with information on the access code, its expiry date etc.
-
Page 15: Technical Specification
7.4.7. Records - device logbook. 7.4.8. Settings – clicking the Settings icon provides us with information on the device: - lock id - lock no.; - MAC - MAC adress; - Battery - battery status; - Validity - access validity; - Lock name - here you can enter the lock name, e.g. - Page 16 The Eura-Tech Sp. z o.o. company reserves the right to change technical parameters and modify the operating instructions without notification. At the same time, we would like to inform that the most up-to-date version of the manual can be found on the website www.eura-tech.eu on the subpage of the given product.
Need help?
Do you have a question about the ELH-72B9 SILVER and is the answer not in the manual?
Questions and answers