HP 2000i Reference Manual page 93

Table 14 Event code descriptions and recommended actions (continued)
Event Event type Description
code
75 Informational The specified volume's LUN has been
unassigned because it conflicts with LUNs
assigned to other volumes. This can happen
when disks containing data for a mapped
volume have been inserted from another
enclosure.
76 Informational The controller is using default configuration
settings. This event occurs on the first power
up, and might occur after a firmware update.
77 Informational The cache was initialized as a result of
power up or failover.
78 Warning The controller could not use an assigned
spare for a vdisk because the spare's
capacity is too small. This occurs when a
vdisk's status becomes critical and all global
spares are too small or (if dynamic spares
are enabled) all disks are too small.
79 Informational The trust vdisk operation has completed
successfully.
80 Informational The controller has modified mode parameters
on one or more disks.
81 Informational The current controller has unkilled the partner
controller. The other controller will restart.
83 Informational The partner controller is changing state
(shutting down or restarting).
84 Warning In an active-active configuration, the current
controller has forced the partner controller to
fail over for the specified reason.
86 Informational The FC host port or disk parameters have
been changed.
87 Warning The mirrored configuration retrieved by this
controller from the partner controller has bad
cyclic redundancy check (CRC). The local
flash configuration will be used instead.
88 Warning The mirrored configuration retrieved by this
controller from the partner controller is
corrupt. The local flash configuration will be
used instead.
89 Warning The mirrored configuration retrieved by this
controller from the partner controller has a
configuration level that is too high for the
firmware in this controller to process. The
local flash configuration will be used instead.
HP StorageWorks 2000 G2 Modular Smart Array Reference Guide
Recommended action
If you want hosts to access the volume data
on the inserted disks, map the volume with a
different LUN.
If you have just performed a firmware update
and your system requires special
configuration settings, you must make those
configuration changes before your system
will operate as before.
Replace existing spares or add spares with
enough capacity to replace the smallest disk
in the vdisk. The vdisk size is limited by its
disk with the least capacity.
Save the log files and contact a service
technician.
The mirrored configuration is corrupted.
Configuration data on the two controllers
may be out of sync. Clear configuration may
be needed to fully recover from this.
The mirrored configuration is corrupted.
Configuration data on the two controllers
may be out of sync. Clear configuration may
be needed to fully recover from this.
This likely indicates that the current controller
has down-level firmware. Update the
firmware on the down-level controller. Both
controllers should have the same firmware
versions.
When the problem is fixed, event 20 is
logged.
93