Event configuration
You can customize the information reported by Fabric Watch by configuring event behavior types,
threshold values, time bases, and event settings. You cannot change data values; these represent
switch behavior that is updated by the software. The following area attributes are used to define
and detect events in Fabric Watch.
Event behavior types
Based on the number of notifications delivered for events there are two categories of event
behavior types:
•
•
Continuous event behavior
You can set behavior type events to continuous trigger during a given sample period, until the fabric
no longer meets the criteria defined for the event.
As an example, you can configure Fabric Watch to notify you during every sample period that a port
is at full utilization. This information can help you plan network upgrades.
Triggered event behavior
If you do not want notification during each sample period from the port hardware failure to the time
of its repair, you can define the event behavior as triggered. Triggered is the default behavior type
signal for all class areas.
For example, when a port fails, Fabric Watch sends you a notification of the failure. After you repair
the port, Fabric Watch detects the repair. At this time, Fabric Watch determines that the fabric no
longer meets the event criteria, and watches for the error again. The next time the port fails, it
sends you another notification.
Whereas a triggered behavior type sends only one event notification when the fabric meets the
criteria for the event, a continuous behavior type signals you continuously after a threshold has
been crossed.
You can configure the notification settings for Fabric Watch by changing the behavior type in the
Advanced Configuration menu (type 1 at the Select choice => prompt to change the behavior type).
See
Fabric Watch Administrator's Guide
53-1001342-01
Continuous event behavior
Triggered event behavior
"Advanced configuration options"
on page 69 for more information.
Event configuration
6
49