Table of Contents
Advertisement
INSTALLATION
Continued
Washers
Bolt
Leg
Figure 9 - Attaching Stove Legs
Washers
Bolt
Stove
Bottom
Figure 10 - Attaching Stove Bottom
105985
10. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Figure
8 on page 8, and Figure 11). Use an ad-
justable wrench or a 12mm socket to fas-
ten step bolt. Tighten step bolt until snug.
Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-
55mm with two M8 hex nuts) into
threaded hole on stove body (see Fig-
ure 8, page 8). Use an adjustable
wrench or a 12mm socket. The catch
bolt has two hex nuts attached to it (see
Figure 12). The top nut is a bolt stop
and the bottom nut is for door leveling
Bottom Of
adjustment.
Stove Unit
Stove
Door
Door
Hinge
Bottom Of
Stove Unit
Step
Bolt
Bolt
Shoulder
Figure 11 - Attaching Stove Door
Door
Figure 12 - Catch Bolt and Door Claw Orientation
OWNER'S MANUAL
Threaded
Hole
Stove Bottom
Bolt Stop
Adjusting Nut
Door Claw
Catch Bolt
For more information, visit www.desatech.com
9
12. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position.
13. Carefully lift stove back up on its four
attached legs.
14. Set top grate into stove top.
15. If available, install gas log heater in-
side stove cavity before installing the
back panel (see Installing Gas Log
Heater Into Stove, page 10).
16. Fasten back panel to stove with six (6)
M6 x 1 - 20mm bolts and washers.
Make sure product identification label
is located on the outside in lower left-
hand corner.
Stove
Door
Bolt
Shoulder
Door
Hinge
Step
Bolt
Continued
Advertisement
Table of Contents
