Glossary; Setting Up The Remote To Control Your Tv - Pioneer HTS-GS1 - Surround Sound System Operating Instructions Manual

Additional information
Use in an excessively dusty or damp environment.
Place directly on top of an amplifier, or other component in
your stereo system that becomes hot in use.
Use near a television or monitor as you may experience
interference—especially if the television uses an indoor
antenna.
Use in a kitchen or other room where the system may be
exposed to smoke or steam.
Use on a thick rug or carpet, or cover with cloth—this may
prevent proper cooling of the system unit.
Place on an unstable surface, or one that is not large enough
to support all four of the system unit's feet.

Glossary

Dolby Digital A multi-channel audio encoding
system developed by Dolby
Laboratories that enables far more
audio to be stored on a disc than
PCM encoding.
Dolby A matrix decoding technology
Pro Logic II
developed by Dolby Laboratories that
expands any two-channel source
audio, such as CDs and TV
broadcasts, to a five-channel
playback (left/center/right/left
surround/right surround), resulting
in a surround experience.
DTS
A multi-channel audio encoding
system developed by Digital Theater
Systems that enables far more audio
to be stored on a disc than PCM
encoding.
Manufactured under license from Dolby Laboratories.
"Dolby", "Pro Logic" and the double-D symbol are
trademarks of Dolby Laboratories.
"DTS" and "DTS Digital Surround" are registered
trademarks of Digital Theater Systems, Inc.
The Windows logo, Windows Media, Xbox 360 and the Xbox
logos are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other
countries and are used under license from Microsoft.
Setting up the remote to control your
TV
You can use the supplied remote to control your TV. To be
able to use this feature you first have to program the
remote with a maker code from the table on the following
page.
BACK
CHANNEL –
PREV NEXT
AUDIO
SETUP /TUNE
–
/ST ENTER
SOUND /TUNE
SURROUND ADVANCED
0
TV CONTROL
+
INPUT CHANNEL
–
1 Switch on your TV.
2 Press and hold down the BACK button, then enter
the maker code for your TV.
The following table shows which buttons on the remote
correspond to which numbers.
Remote
Number
button
1 SETUP
2 TUNE+
3 SR+
4 ST–
5 ENTER
See the table on the next page for the list of maker codes.
If there is more than one code given for your maker, input
the first one in the list.
• If the maker's name of your TV doesn't appear in the
table, you will not be able to use this remote to
control your TV.
3 Point the remote towards your TV and press
to check that the remote works with your TV.
If the remote is set up correctly, the TV should switch off.
If it doesn't and there is another code given for your
maker, repeat step 2 with a new code.
ENTER
VOLUME
ANGLE PLAY MODE
TIMER REC REC MODE
+ +
SR ONE TOUCH COPY
+
/ST MENU
–
TEST TONE SLEEP
TV/DVD
JUKE BOX
+
VOLUME DISPLAY
–
RDS DISP
Number Remote button
6 ST+
7 SOUND
8 TUNE–
9 TEST TONE
0 SLEEP
TV
09
31
En