Adobe LIVE CYCLE 7.2 - INSTALLING AND CONFIGURING LIVECYCLE FOR JBOSS Manual page 22

Adobe LiveCycle
Installing and Configuring LiveCycle for JBoss
12. Review the installation details, and then click Install. A summary screen appears when the product
installation is completed.
13. On the summary screen, you have the following options:
If you are installing only one LiveCycle product or this is the last LiveCycle product you are installing,
●
select Launch the Configuration Manager, and then click Finish. Proceed to step 14.
If you plan to install additional LiveCycle products, click Finish to exit the installation program and
●
run the installation programs for the additional products.
14. If prompted, select a language for Configuration Manager and click OK.
15. On the Welcome screen, click Next.
16. On the Configuration Mode screen, select Typical Configuration Wizard and click Next.
17. If prompted, on the Configuration Preferences screen, select either Use Previously Entered Values or
Revert to Default Values, and then click Next.
Note:
18. If required, on the Product Selection screen, select JBoss as the type of application server that you are
using.
19. If required, select Foundation and the products that you want to configure and deploy, and then click
Next.
20. (LiveCycle Forms) On the Adobe User Management Selection screen, select either LiveCycle Forms
with User Management and Administration or LiveCycle Forms without User Management and
Administration, and then click Next.
21. On the Configuration and Assemble Products screen, click Next.
22. Review the Application Configuration and Assembly Summary details, and then click Next.
Configuration Manager configures the LiveCycle product properties using the default values and
assembles the products into the LiveCycle.ear file.
23. When the configuration and assembly is complete, click Next.
24. On the Deploy LiveCycle screen, click Next.
25. On the Deploy products summary screen, click Next.
26. In the Application Server Base URL box, type the URL that Configuration Manager can use to connect
to the application server, and then click Next. The URL must be in the following format:
http://[host name]:[port]
where
[port]
27. On the Prepare database for LiveCycle screen, click Next.
28. On the Deployment Instructions screen, click Next.
This screen only appears if you have previously run Configuration Manager.
is the name or IP address of the computer that hosts the application server, and
[host name]
is the HTTP service port that the application server uses (for example, http://localhost:8080).
Installing LiveCycle Products Using the Turnkey Installation
Running the turnkey installation 22