Installing Coldfusion Mx 6.1 On Unix - MACROMEDIA COLDFUSION MX 61 - INSTALLING AND USING COLDFUSION MX Using Manual

Open cf_root/lib/adminconfig.xml (server configuration) or cf_root/WEB-
b
INF/cfusion/lib/adminconfig.xml (J2EE configuration) in a text editor, change
runmigrationwizard
(migrate the ColdFusion MX ODBC services to ColdFusion MX 6.1) to true, as necessary,
and save the file.
Restart the ColdFusion MX Administrator from the Windows Start menu.
c
You are prompted again to migrate your settings.
Caution: If you migrate your ColdFusion 5 settings later, you might overwrite new ColdFusion MX
settings.
Configure and manage your system, as described in
12
on page 49.
To learn about ColdFusion MX 6.1, read the documentation, which is accessible through the
13
Documentation link at the top of the ColdFusion MX Administrator.

Installing ColdFusion MX 6.1 on UNIX

This section explains how to install ColdFusion MX 6.1 on UNIX.
By default, ColdFusion MX 6.1 installs into the /opt/coldfusionmx directory. To install it into a
different directory, you must create that directory before running the installation.
Note: The UNIX installer defaults to running ColdFusion MX 6.1 as user nobody. However, this is not
allowed on HP-UX, so you must change the default value. On HP-UX, it is best to run as the same
user as the web server runs under.
(migrate ColdFusion 5 settings) and
runmxmigrationwizard
Chapter 4, "Configuring Your System,"
Installing ColdFusion MX 6.1 23