GRASS VALLEY 8910ADA-SR Datasheet

4 8910ADA-SR Stereo Analog Audio DA w/Remote Control
Key Features
• Stereo and monaural modes
• Audio presence detection with SNMP
reporting
• Frequency response of 20 Hz to 20 kHz
±0.05 dB
• Gain/balance level controls
• Gain range from –20 dB to +30 dB set
with remote controls or front edge paddle
switch
• Sum, swap, or invert signals
• Max. output level +28 dBu
• Hard-wired potentiometers via rear
BNC connectors for ±6 dB fine gain and
balance control in Local Mode
• Input present (>–40 dBu) detection
• Remote monitoring and control via
Ethernet
Specifications Specifications Specifications
Supported Frame Types
GeckoFlex with 8900A-R GeckoFlex Audio rear
module, Gecko audio frames: 8900TX-A, 8900TF-A,
8900TFN-A
Power Rating
5 Watts – single slot
Input
Impedance: 18 kΩ to 30 kΩ
Level: +30 dBu max.
CMRR: >72 dB, 60 Hz to 20 kHz
Output
Number of outputs: Four balanced stereo outputs or
eight balanced monaural outputs
Impedance: <50Ω balanced
Level: ≤+28 dBu
Level match between outputs: ≤±0.25 dB
Gain tracking between channels: <0.3 dB
Output to output isolation: >100 dB
The 8910ADA-SR offers full-featured
distribution of monaural or stereo analog audio
signals. In stereo mode, there are four stereo
outputs, and in monaural mode there are eight
outputs. With this module, audio signals can
be summed for monaural monitoring, swapped
L to R, or phase inverted to fix upstream
transmission problems. Featuring flat frequency
response to maintain signal integrity, the
8910ADA-SR offers a wide range of gain and
balance control options, including local module
control (using paddle controls and a hard-wired
potentiometer for fine adjustment of
±6 dB)
Ethernet-connected Newton control panels,
™
and Web browser interface. The user-enabled
audio presence detection feature generates
SNMP traps that can be sent to our NetCentral
SNMP manager, or other SNMP systems for
mission-critical applications.
Balanced
Inputs
Audio
Input 1
Audio
Input 2
Hard-wired
poteniometer
for fine Gain
Processing
Hard-wired
potentiometer
for fine Balance
Balance
Gain
Performance
Frequency response: 20 Hz to 20 kHz ±0.05 dB
THD: <0.05% @ 24 dBu
IM distortion: <0.025% @ 24 dBu
Noise: –75 dBu max.
Crosstalk: >95 dB 20–20 kHz @ 0 dB
Overall gain range: –20 to +30 dB
Hard-wired potentiometer
gain/balance range (local mode only): ±6.0 dB
Other
User gain controls: Input gain, –12 dB to +30 dB,
stereo/mono mode select
Operating temperature: 0° to 45°C
Humidity range: 0% to 90% non-condensing
Non-operating temperature: –10° to 70°C
Remote – SNMP alarm
Pin 3
+
8900A-R
_
Pin 2
G
Pin 1
Analog
Audio 1
Outputs
Analog
Audio 1
Intput
Potentiometer
Gain
,
Not Used
Digital
0.1 dB Volume Control
Gain
(0.5 dB
Trim
resolution)
Digital
0.1 dB
Volume Control
Gain
(0.5 dB
Trim
resolution)
Sum
Analog
Swap
Modes
&
A/D
Processor
Ordering Information Ordering Information Ordering Information
This module can be mounted in a GeckoFlex
frame when ordered with the 8900A-R GeckoFlex
Audio rear module.
8910ADA-SR
Stereo analog audio distribution amplifier with remote
control
8900-A-CBL (Gecko Frames only)
Package of four three-terminal to dual BNC cables,
used for unbalanced outputs on modules in a Gecko
frame
8900-GFA-CBL (GeckoFlex Frames only)
Package of four three-terminal to dual BNC cables,
used for unbalanced outputs on 8900A-R modules in a
GeckoFlex frame
For detailed specifications, installation, and setup
instructions see:
www.grassvalley.com/docs/modular
Pin 1
G
_
Pin 2
+
Pin 3
J1
J2
J3
Analog
Audio 2
J4
J5
Outputs
J6
J7
J8
Analog
J9
Audio 2
Intput
J10
J11
Potentiometer
Balance
J12
J13
Not Used
J14
Balanced
Outputs
Audio 1
Output
Channel 1
Output Amps
Channel 2
Output Amps
Audio 2
Output
LEDs