Upconverter Configuration
Models with upconverters are factory set for composite video. For S-video or
component, follow the procedure below to set the input switches as needed
before installing the VM1 (see diagram).
CAUTION: This procedure is for qualified personnel only. To reduce
the risk of electric shock, do not perform this procedure unless you are
qualified to do so.
Component
Composite
1 2 3 4
1 2 3 4
Source 1
O
O
1 2 3 4
1 2 3 4
Source 4
O
O
Required DIP switch positions shown in black
Rev. 1
Upconverter input DIP switch settings
For Sources 1 and 4
S-video
1 2 3 4
O
1 2 3 4
O
Back panel of VM1
Top view of VM1 8UC2 interior showing upconverter
Russound VM1 Installation Manual
1.
Turn off the power switch.
2.
Unplug the power supply from the VM1 chassis.
3.
Remove the 9 cover screws on the rear and sides.
4.
Pull the cover up off the chassis, lifting one side first and then the other.
5.
Set the switches as shown in the table below.
6.
Replace the cover and screws.
For Sources 5 and 8
input switch locations
UpCONVERTER CONFIGURATION
Component
Composite
1 2 3 4
1 2 3 4
Source 5
O
O
1 2 3 4
1 2 3 4
Source 8
O
O
Required DIP switch positions shown in black
S-video
1 2 3 4
O
1 2 3 4
O
7