Table of Contents
Advertisement
Chapter 2. Installation Guide
2.1 Hardware Installation
To install the Adapter, follow these steps listed below:
1.
Turn off your desktop PC and disconnect the power.
2.
Open your PC case and locate an available PCI slot on the motherboard. Remove the metal
slot cover on the back of the PC. Check with your computer manufacturer for instructions if
needed.
3.
Slide the PCI Adapter into the PCI slot. Make sure that all of its pins are touching the slot's
contacts. Once the adapter is firmly in place, secure its fastening tab to your PC's chassis
with a mounting screw. Then, close your PC case.
4.
Reconnect your PC's power and turn on your desktop PC.
2.2 Software Installation
2.2.1 Overview
The Adapter's Setup Wizard will guide you through the Installation procedure for Windows 2000,
XP. The Setup Wizard will install the TP-LINK Wireless Client Utility (TWCU) and drivers.
When you install the hardware before installing the software, the system will prompt "Found New
Hardware Wizard", click Cancel, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 2000 and XP are very similar. The following setup steps are for
Windows 2000.
2.2.2 Software Installation for Windows 2000
1.
Insert the Resource CD into your CD-ROM drive, Click the Start button and choose Run. In
the field that appears, enter F:\XXX\setup.exe (if "F" is the letter of your CD-ROM drive, XXX
represents the setup program path, which is labeled on the Resource CD), then Figure 2-1
will appear.
TL-WN350G
54M Wireless PCI Adapter User Guide
2
Advertisement
Table of Contents
