Table of Contents
Advertisement
Chapter2 Installation Guide
2.1 Hardware Installation
To install the adapter, follow these steps listed below:
1.
Turn off your notebook PC and disconnect the power.
2.
Remove your notebook PC case and locate the available Mini PCI slot on the motherboard.
Check with your computer manufacturer for instructions if needed.
3.
Slide the Adapter into the Mini PCI slot. Make sure that all of its pins are touching the slot's
contacts. Then fasten the Adapter to your PC's chassis with a mounting screw, set up the
antenna and replace your PC case.
4.
Reconnect your PC's power and turn on your notebook PC.
2.2 Software Installation
2.2.1
Overview
The Adapter's Setup Wizard will guide you through the Installation procedure for Windows 2000,
XP86, Vista32, and Vista64. The Setup Wizard will install the TP-LINK Wireless Client Utility
(TWCU) and drivers.
When you install the hardware before installing the software, the system will prompt "Found
New Hardware Wizard", click Cancel, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 2000, XP are very similar. The following setup steps are for
Windows XP.
2.2.2
Software Installation for Windows XP
1.
Insert the Resource CD into your CD-ROM drive, and the Figure 2-1 will appear. To continue,
select the TL-WN360G and there will be a menu display, including: Driver(Vista) and
Driver(Win2000_XP).
TL-WN360G
54M Wireless Mini PCI Adapter User Guide
- 3 -
Advertisement
Table of Contents
