Table of Contents
Advertisement
TL-WN510G/TL-WN550G/TL-WN551G
Chapter 2 Installation Guide
2.1 Hardware Installation
2.1.1 TL-WN550G/TL-WN551G Hardware Installation
To install the adapter, follow these steps listed as below:
1.
Turn off your desktop PC and disconnect the power.
2.
Remove your PC case and locate an available PCI slot on the mainboard. Remove
the metal slot cover on the back of the PC. Check with your computer manufacturer
for instructions if needed.
3.
Slide the PCI Adapter into the PCI slot. Make sure that all of its pins are touching the
slot's contacts. Once the adapter is firmly in place, secure its fastening tab to your
PC's chassis with a mounting screw. Then, close your PC case.
4.
Reconnect your PC's power and turn on your desktop PC.
2.1.2 TL-WN510G Hardware Installation
To install the adapter, follow these steps listed as below:
1.
Locate an available CardBus slot on your laptop.
2.
With the connector pin end facing the CardBus slot and the label facing up, slide the
Adapter into the CardBus slot until it locks in place.
3.
The promoted Found New Hardware Wizard screen will pop up when the adapter is
installed correctly.
2.2 Software Installation
2.2.1 Overview
The Adapter's Setup Wizard will guide you through the Installation procedure for Windows
98SE, Me, 2000, XP, Vista. The Setup Wizard will install the TP-LINK Wireless Client
Utility (TWCU) and drivers.
When you install the hardware before installing the software, the system will prompt
"Found New Hardware Wizard", click Cancel, and run the Setup Wizard program on the
CD-ROM.
The Setup steps for Windows 98SE, Me, 2000, XP are very similar. The following setup
steps are for Windows 2000 and the section 2.2.3 for Windows Vista.
Note: The Adapter doesn't have utility for windows Vista.
54M Wireless Adapter User Guide
4
Hide quick links:
Advertisement
Table of Contents
