Filters - Hoover FloorMate SpinScrub H3040RM Owner's Manual

dirtY water tank
automatic "shut Off"
An automatic suction shut-off is built into the Dirty
Water Tank to prevent the tank from overflowing.
When the shut-off activates, the cleaner will not pick
up debris and the sound of the motor will change.
The Dirty Water Tank is full and must be emptied.
how to empty
turn cleaner off and disconnect from electrical
outlet.
Although not necessary
performance, it is recommended that the Dirty
Water Tank be emptied after dry vacuuming and
before wet operation.
Check the Clean Water Solution Tank also. It may
need to be refilled at this time.
2.15 To remove tank, press down on release button
(G) and pull tank straight out.
2.16 Remove tank lid (H). Empty tank.

filters

The tank lid contains a washable, reusable filter.
Clean this filter when suction is low or reduced.
how to Clean
turn cleaner off and disconnect from electrical
outlet.
2.17 Remove Dirty Water Tank and lid (Figs. 2.15 &
2.16). Remove filter lid (A), then remove filter (B).
Remove loose debris from filter by tapping the filter
or gently brushing using your hand. The filter may
also be rinsed for additional cleaning. Allow filter to
air dry between uses.
Reposition filter.
2.18 Replace filter lid. Press down firmly until
snapped in place.
Dry or loose debris will also collect on the filter
screen located in the tank lid.
2.19 To remove debris from screen, remove the
pleated filter from the lid. Remove debris from
screen (C).
The filter screen may also be cleaned by rinsing it
under running water.
Reposition pleated filter in lid. Replace lid onto Dirty
Water Tank, pressing down firmly until snapped in
place.
2.20 To replace Dirty Water Tank, place bottom of
tank behind ledge (D) and push tank straight into
cleaner body until it is locked in place.
(lower tank)
for satisfactory
2.15
G
2.17
b
2.19
9
2.16
2.18
a
2.20
C
e
H