Port State Description; Table 3 Port State Description - Brocade Communications Systems 8 Administrator's Manual

9. Enter the switchDisable command to disable the switch.
10. Enter the ag command with the
11. Enter the ag

Port state description

The following table describes the possible port states.
TABLE 3
State
No _Card
No _Module
Mod_Val
Mod_Inv
No_Light
No_Sync
In_Sync
Laser_Flt
Port_Flt
Diag_Flt
Lock_Ref
Testing
Offline
Online
Access Gateway Administrator's Guide
53-1001760-01
When you disable AG mode, The switch automatically reboots and comes back online using the
fabric switch configuration; the AG parameters, such as port mapping, and Failover and
Failback are automatically removed. When the switch reboots, it starts in Fabric OS Native
mode. To re-join the switch to the core fabric, refer to
on page 67.
switch:admin> switchdisable
switch:admin> ag --modedisable
modeshow command to verify that AG mode is disabled.
--
switch:admin> ag --modeshow
Access Gateway mode is NOT enabled
Port state description
Description
No interface card present
No module (GBIC or other) present
Module validation in process
Invalid module
The module is not receiving light
Receiving light but out of sync
Receiving light and in sync
Module is signaling a laser fault
Port marked faulty
Port failed diagnostics
Locking to the reference signal
Running diagnostics
Connection not established (only for virtual ports)
The port is up and running
Enabling and disabling Access Gateway mode
"Rejoining Fabric OS switches to a fabric"
modedisable operand to disable AG mode.
--
2
9