Floppy Drive; Mounting The Floppy Drive; Removing The Floppy Drive - Asus AP140R User Manual

3.2 Floppy Drive

The 1U server comes with a slim floppy disk drive already installed.
Refer to this section if you need to remove and re-install the floppy
drive in the future.

Removing the Floppy Drive

1. Disconnect the floppy cable
from the rear of the drive.
2. Remove the screws that
secure the floppy drive. The
picture on the right shows the
locations of the screws.
3. Slide the floppy drive cage out
of the bay.
4. The drive is secured by four
screws (two on each side) to
the cage. Remove these
screws to detach the drive from
the cage.

Mounting the Floppy Drive

1. Place the floppy drive into the
drive cage as shown.
2. Secure the drive to the cage
with the four screws that you
removed earlier.
AP140R Server User's Manual
Slim Floppy Disk Drive Cable
31