Sony SNC-VL10N Quick Reference page 16

Hexagonal wrench
(supplied)
Flange focal length
adjustment ring
Note
Do not loosen the flange focal length
adjustment ring excessively. The ring
may be damaged if you loosen it until
the silver base of the ring appears.
This way
7
Repeat steps 3 to 6 until you
achieve sharp focus both in the
telephoto and wide-angle
positions.
8
Tighten the fixing screw using
the hexagonal wrench.
16
GB
Installing the Camera
Not this way
Silver base
When the supplied vari-focal lens is
replaced
1
Point the camera to a subject
about 20 cm (8 inches) away.
A subject, on which you can observe the
focus condition distinctively, such as
letters, fine patterns, etc, is suitable.
2
Turn the zoom ring of the lens
fully to WIDE.
3
Turn the focus ring of the lens
fully to (infinite).
4
Loosen the fixing screw using
the supplied hexagonal wrench,
and turn the flange focal length
adjustment ring until the correct
focus is obtained.
Hexagonal wrench
(supplied)
Flange focal length adjustment ring
5
Tighten the fixing screw using
the hexagonal wrench.