Toro 39926 Operator's Manual

Toro 39926 Operator's Manual

Ha 60v snowthrower

Advertisement

Quick Links

Power Max
Model No. 39926—Serial No. 400000000 and Up
Model No. 39926T—Serial No. 400000000 and Up

Introduction

This machine is intended to be used by residential
homeowners. It is designed primarily for removing
snow from paved surfaces, such as driveways and
sidewalks, and other surfaces for traffic on residential
or commercial properties. It is not designed for
removing materials other than snow. It is designed to
use Toro Flex-Force lithium-ion battery pack Model
88675 (2 provided with Model 39926), 88660, 88650,
88640, 88625, or 88620. These battery packs are
designed to be charged only by battery charger
Models 88602 (provided with Model 39926), 88605,
or 88610. Using this product for purposes other than
its intended use could prove dangerous to you and
bystanders.
Model 39926T does not include a battery or a
charger.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for product safety and operation
training materials, accessory information, help finding
a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Important:
With your mobile device, you can
scan the QR code on the serial number decal (if
equipped) to access warranty, parts, and other
product information.
© 2021—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
e26 HA 60V Snowthrower
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
serious injury or death if you do not follow the
recommended precautions.
Figure 1
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Register at www.Toro.com.
Figure 1
1. Model and serial number location
Model No.
Serial No.
2), which signals a hazard that may cause
Figure 2
Safety-alert symbol
Original Instructions (EN)
Printed in Mexico
All Rights Reserved
Form No. 3444-293 Rev A
Operator's Manual
g344085
g000502
*3444-293*

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 39926 and is the answer not in the manual?

Questions and answers

Summarization of Contents

Safety Guidelines and Precautions
Operator Training and Responsibilities
Operator's responsibilities, understanding the manual, and proper use.
Pre-Operation Safety Checks
Keeping area clear, ensuring guards are in place, and using correct battery.
Safe Operation Practices
Safe operation guidelines, avoiding contact with moving parts, and attentiveness.
Maintenance and Storage Safety
Procedures for adjusting, servicing, cleaning, and storing the machine safely.
Safety and Instructional Decals
Decal Explanations and Meanings
Explanation of various safety decals and their meanings on the machine.
Snowthrower Setup Procedures
Mounting the Battery Charger
Instructions for securely mounting the battery charger indoors near a power outlet.
Installing the Upper Handle
Procedure for attaching the upper handle to the snowthrower.
Installing the Discharge Chute
Steps for correctly mounting the discharge chute onto the machine.
Installing the Traction-Control Linkage
Guidance on connecting the linkage that controls the traction drive.
Installing the Chute-Control Rod
Steps to install the rod used for adjusting the discharge chute direction.
Installing the Snow-Cleanout Tool
Instructions for attaching the tool used for clearing the discharge chute.
Checking Tire Pressure
Procedure to verify and adjust tire pressure to the recommended level.
Checking Skids and Scraper
Inspecting and adjusting skids and scraper for proper ground clearance.
Adjusting Auger/Impeller Cable
How to adjust the cable that controls the auger and impeller engagement.
Checking Traction Drive Operation
Verifying the proper functioning of the machine's traction system.
Product Overview and Components
Snowthrower Component Identification
Labeled diagram identifying key parts and controls of the snowthrower.
Specifications and Compatibility
Model, Battery, and Charger Details
Details on model numbers, weight, dimensions, battery, and charger specifications.
Operating Temperature Ranges
Recommended temperature limits for charging, using the battery, and the machine.
Approved Attachments and Accessories
Information on approved attachments and accessories for the snowthrower.
Operating the Snowthrower
Before Operation Checks
Pre-operational checks and setup, including battery installation and controls.
Headlight and Handwarmer Activation
How to activate the headlight and handwarmer features.
Operating Handwarmers
Instructions for turning the handwarmers on and off.
Activating ECO Mode
Using ECO mode to extend battery life by reducing rotor speed.
Starting the Snowthrower
Steps for safely starting the snowthrower using the key switch.
Operating the Traction Drive
How to engage and disengage the machine's forward and reverse drive system.
Operating the Speed Selector
Guidance on changing between the six forward and two reverse speeds.
Operating the Auger/Impeller Drive
How to engage and disengage the auger and impeller system.
Operating the Quick Stick Control
Using the Quick Stick control for chute and deflector adjustments.
Moving the Discharge Chute
Adjusting the direction of the snow discharge chute.
Moving the Chute Deflector
Adjusting the angle of the chute deflector.
Clearing a Clogged Discharge Chute
Procedures for safely clearing a blocked discharge chute.
General Operating Tips
Advice for optimal performance and safe operation in various snow conditions.
Maintenance and Adjustments
Recommended Maintenance Schedule
A schedule outlining required maintenance tasks at different service intervals.
Preparing for Maintenance
Steps to ensure the machine is safe before performing any maintenance.
Checking and Adjusting Skids and Scraper
Inspecting and adjusting skids/scraper to prevent auger contact with surfaces.
Checking and Adjusting Traction Cable
How to check and adjust the traction cable for proper drive engagement.
Checking and Adjusting Auger/Impeller Cable
Procedure for inspecting and adjusting the auger/impeller engagement cable.
Checking Auger-Gearbox-Oil Level
How to check and maintain the oil level in the auger gearbox.
Lubricating the Hex Shaft
Instructions for lubricating the hex shaft for smooth operation.
Adjusting Discharge-Chute Latch
Adjusting the chute latch mechanism for secure locking and unlocking.
Replacing Drive Belts
Guidance on replacing worn or damaged auger/impeller or traction drive belts.
Storage and Battery Disposal
Storing the Snowthrower and Accessories
Guidelines for preparing and storing the snowthrower, battery, and charger.
Preparing Battery Pack for Recycling
Instructions for safely preparing the battery pack for recycling.
Troubleshooting Common Issues
Machine Not Running or Running Intermittently
Diagnosing and fixing issues where the machine won't start or stops unexpectedly.
Machine Lacks Full Power
Troubleshooting low power issues related to the battery or air vents.
Poor Snow Discharge Performance
Addressing problems with the machine discharging snow slowly or not at all.
Discharge Chute Malfunctions
Resolving problems with the discharge chute not locking or moving.
Surface Clearing Inefficiencies
Fixing issues where the machine doesn't properly clear snow from the surface.
Rapid Battery Pack Charge Loss
Diagnosing why the battery pack drains charge faster than expected.
Battery Charger Not Functioning
Troubleshooting issues with the battery charger itself or its power source.
Battery Charger Red LED Indicator
Understanding and resolving the red LED indicator on the battery charger.
Battery Charger Blinking Red LED
Diagnosing and fixing issues indicated by a blinking red LED on the charger.

Table of Contents